Abstract:This study characterized the coagulation properties and defined the cutting window (CW; time between storage modulus values of 35 and 70 Pa) using rheometry for milk standardized to 4, 5, or 6% protein and set at 28, 32, or 36°C. Milks were standardized to a protein-to-fat ratio of approximately 1 by blending ultrafiltration retentate, skim milk, and whole milk. The internal curd microstructure for selected curd samples was analyzed with transmission electron microscopy and scanning electron microscopy. Lowering the coagulation temperature caused longer rennet coagulation time and time to reach storage modulus of 35 Pa, translating into a wider CW. It also led to a lower maximum curd-firming rate (MCFR) with lower firmness at 40 min at a given protein level. Increasing protein levels resulted in the opposite effect, although without an effect on rennet coagulation time at a given temperature. On coagulation at 28°C, milk with 5% protein resulted in a similar MCFR (∼4 Pa/min) and CW (∼8.25 min) compared with milk with 4% protein at 32°C, which reflects more standard conditions, whereas increasing milk to 6% protein resulted in more than doubling of the curd-firming rate (MCFR = 9.20 Pa/min) and a shorter CW (4.60 min). Gels set at 28°C had lower levels of rearrangement of protein network after 40 min compared with those set at 36°C. Protein levels, on the other hand, had no influence on the levels of protein network rearrangement, as indicated by loss tangent values. The internal structure of curd particles, as investigated by both scanning electron microscopy and transmission electron microscopy, appeared to have less cross-linking and smaller casein aggregates when coagulated at 28°C compared with 36°C, whereas varying protein levels did not show a marked effect on aggregate formation. Overall, this study showed a marked interactive effect between coagulation temperature and protein standardization of milk on coagulation properties, which subsequently requires adjustment of the CW during cheesemaking. Lowering of the coagulation temperature greatly altered the curd microstructure, with a tendency for less syneresis during cutting. Further research is required to quantify the changes in syneresis and in fat and protein losses to whey due to changes in the microstructure of curd particles arising from the different coagulation conditions applied to the protein-fortified milk.

Quantifying thermally induced flowability of rennet cheese curds

Influence of pH on Heat-Induced Changes in Skim Milk Containing Various Levels of Micellar Calcium Phosphate

Influence of acidification and re-neutralization on mineral equilibria and physicochemical properties of model cheese feed

Effect of milk fat content on the viscoelasticity of mozzarella-type cheese curds

Influence of protein concentration and coagulation temperature on rennet-induced gelation characteristics and curd microstructure

Cold-Renneted Milk Powders for Cheese Production: Impact of Casein/Whey Protein Ratio and Heat on the Gelling Behavior of Reconstituted Rennet Gels and on the Survival Rate of Integrated Lactic Acid Bacteria

Dextran modulates physical properties of rennet‐induced milk gels

Rheological and structural properties of differently acidified and renneted milk gels

Functionality and physico-chemical characteristics of bovine and caprine mozzarella cheeses during refrigerated storage

Impact of ultrasonic and heat treatments on the physicochemical properties and rennet-induced coagulation characteristics of milk from various species

Effect of lactose standardization of milk using low-concentration factor ultrafiltration: Effect of reducing the lactose-to-casein ratio on the properties of milled-curd Cheddar cheese

Process Study of Cheese Producted by a New Rennase

Extent of κ‐casein hydrolysis during renneting of bovine milk: A critical assessment of the analytical and estimation approaches

Textural, rheological and microstructural properties of imitation cheese containing inulin

Kinetic Modelling of the Heat Stability of Bovine Lactoferrin in Raw Whole Milk

Modelling of dynamic mastication physics of cheese/casein gels as function of milk-fat distribution and intensity of thermo-mechanical treatment

Application of Calcium Citrate in the Manufacture of Acid Rennet Cheese Produced from High-Heat-Treated Goat's Milk from Spring and Autumn Season

Changes of physicochemical and functional properties of processed cheese made with natural cheddar and mozzarella cheeses during refrigerated storage

Study of proteolysis, lipolysis, and volatile compounds of a Camembert-type cheese manufactured using a freeze-dried Tibetan kefir co-culture during ripening

Measuring insoluble calcium content in curds during cheesemaking

Inline Determination of the Gel Elastic Modulus During Milk Coagulation Using a Multifiber Optical Probe