A System Analysis of Micron-Gap Thermophotovoltaic Systems Enhanced by Nanowires

Mohammad Sajjad Mirmoosa,Constantin Simovski

DOI: https://doi.org/10.1016/j.photonics.2014.10.007

2014-09-05

Abstract:We introduce new micron-gap thermophotovoltaic systems enhanced by tungsten nanowires. We theoretically show that these systems allow the frequency-selective super-Planckian spectrum of radiative heat transfer that promises a very efficient generation of electricity. Our system analysis covers practical aspects such as output power per unit area and efficiency of the tap water cooling.

Mesoscale and Nanoscale Physics

What problem does this paper attempt to address?

The problem that this paper attempts to solve is to improve the efficiency of thermophotovoltaic (TPV) systems, especially by introducing a micro - gap thermophotovoltaic system enhanced by tungsten nanowires to achieve super - Planckian radiative heat transfer (SP RHT). Specifically:

1. **Problems of existing TPV systems**:
- The electrical power output per unit area of traditional TPV systems is far below the theoretical maximum.
- The spectra emitted by the emitter are too broad, resulting in a large amount of energy waste. For example, the relative bandwidth (BW) of a black - body emitter exceeds 500% at the 10% level, while the operating bandwidth of PV semiconductors is only about 100%.
- Harmful radiation (radiation below the semiconductor band - gap frequency) will heat the PV panel and disrupt its operation.

2. **Proposed solutions**:
- Introduce a frequency - selective emitter so that its radiation spectrum is close to black - body radiation within the PV operating band and as weak as possible outside the band.
- Use metamaterials (such as hyperbolic metamaterials HMMs) to fill the micro - gaps to achieve SP RHT, thereby exceeding the black - body radiation limit.
- Through optimized design, reduce harmful radiation and increase the proportion of useful radiation, and ensure that the system is compatible with standard cooling systems.

3. **Specific objectives**:
- Develop a new structure that can achieve frequency - selective SP RHT in a micro - gap TPV system, so that RHT is higher than the Planck limit within the PV operating band and weak enough outside the band.
- Ensure that the newly designed structure can effectively dissipate heat, maintain the working temperature of the PV panel, and simplify the manufacturing process to avoid direct contact between the hot and cold parts.

4. **Research methods**:
- Propose two new design schemes for micro - gap TPV systems, using metal (such as tungsten) nanowire arrays and multilayer structures.
- Calculate the radiative heat transfer (RHT) by the equivalent circuit method and the effective medium model (EMM), and perform numerical optimization.
- Analyze the influence of different structures on RHT, compare the cases with and without nanowires, and evaluate the gain relative to black - body radiation.

In summary, this paper aims to significantly improve the electrical output efficiency and practicality of thermophotovoltaic systems by introducing frequency - selective emitters and optimizing the structural design of micro - gap TPV systems.