Abstract:Surface topography strongly modifies adhesion of hard-material contacts, yet roughness of real surfaces typically exists over many length scales. This investigation aims to determine which scales of topography have the strongest effect on macroscopic adhesion. Adhesion measurements were performed on technology-relevant diamond coatings of varying roughness using spherical ruby probes that are large enough ($0.5$-mm-diameter) to sample all length scales of topography. For each material, more than $2000$ measurements of pull-off force were performed in order to investigate the magnitude and statistical distribution of adhesion. Using sphere-contact models, the roughness-dependent effective values of work of adhesion were measured, ranging from $0.08$ to $7.15$ mJ/m$^2$ across the four surfaces. The data was more accurately fit using numerical analysis, where an interaction potential was integrated over the AFM-measured topography of all contacting surfaces. These calculations revealed that consideration of nanometer-scale plasticity in the materials was crucial for a good quantitative fit of the measurements, and the presence of such plasticity was confirmed with AFM measurements of the probe after testing. This analysis enabled the extraction of geometry-independent material parameters; the intrinsic work of adhesion between ruby and diamond was determined to be $46.3$ mJ/m$^2$. The range of adhesion was $5.6$ nm, which is longer than is typically assumed for atomic interactions, but is in agreement with other recent investigations. Finally, the numerical analysis was repeated for the same surfaces but this time with different length-scales of roughness included or filtered out. The results demonstrate a critical band of length-scales between $43$ nm and $1.8$ nm in lateral size that has the strongest effect on the total adhesive force for these hard, rough contacts.

Theory of adhesion: role of surface roughness

Elastic behavior of single polymer chains adsorbed on rough surfaces

Strongly Different Adhesion Reduction for 1D or 2D Random Fractal Roughness, and an Extension of the BAM Model to Anisotropic Surfaces

Combined Dry and Wet Adhesion Between a Particle and an Elastic Substrate.

Adhesion Force and Contact Surface Area for Particles with Rough Surfaces

A note on the possibility of roughness enhancement of adhesion in Persson's theory

On roughness-induced adhesion enhancement

Adhesion of Elastic Wavy Surfaces: Interface Strengthening/weakening and Mode Transition Mechanisms

Adhesion between elastic solids with randomly rough surfaces: comparison of analytical theory with molecular dynamics simulations

On a recent very simple generalization of DMT theory of adhesion

When are rough surfaces sticky?

Combined Effects of Viscoelasticity and Surface Roughness on the Adhesion Behavior of a Flat-End Cylindrical Microstructure

Effect of Surface Tension on the Behavior of Adhesive Contact Based on Maugis‒Dugdale Model

Adhesive Contact on Randomly Rough Surfaces Based on the Double-Hertz Model

Hard-material Adhesion: Which Scales of Roughness Matter?

The role of adhesion in contact mechanics

Adhesive Elastic Contact of Rough Surfaces with Power-Law Axisymmetric Asperities

Capillary adhesion between elastic solids with randomly rough surfaces

Do uniform tangential interfacial stresses affect adhesion?

Wet adhesion on rough surfaces: A JKR model with thermodynamic considerations

Contact mechanics for randomly rough surfaces