Abstract:In ducts with varying cross-sectional area and sustaining a subsonic non-isentropic mean flow, the axially varying flow conditions affect the acoustic energy balance of the system. This is significant in understanding and controlling thermo-acoustic phenomena, particularly in combustors. This work aims at quantifying the acoustic energy change in such configurations, using the acoustic absorption coefficient, $\Delta$. The acoustic response of the duct to acoustic forcing is determined using an analytical model, neglecting the effect of entropy fluctuations on the acoustic field, and subsequently, $\Delta$ is estimated. The model predictions of $\Delta$ are validated using a linearised Euler equations (LEEs) solver. The model was found to be accurate for Mach numbers below $0.25$, provided the lower frequency limit set by the analytical solution is satisfied. For conically varying area ducts with linear mean temperature gradient, it was observed that $\Delta$ showed very little dependence on frequency, and that the absolute value of $\Delta$ tended to be maximised when the upstream boundary was anechoic rather than non-anechoic. More importantly, $\Delta$ was also observed to show stronger dependence on the mean temperature gradient than area gradient variation for such configurations. Further parametric and optimisation studies for $\Delta$ revealed a crucial finding that a positive mean temperature gradient, representing a heated duct caused acoustic energy absorption. Similarly, a negative mean temperature gradient, representing a cooled duct caused acoustic energy generation -- a key result of this analysis. This behaviour was shown to be consistent with a simplified analysis of the acoustic energy balance. Based on this finding, a linearly proportional reduction in acoustic energy generation was achieved by changing the mean temperature gradient.

Determination of the characteristics of a linear ducted sound source

Sound radiation from a flanged inclined duct

Experimental Study of Active Control of High Order Acoustic Modes in Ducts

Modeling of flow generated sound in a constricted duct at low Mach number flow

Time-Resolved Flowfield and Acoustic Measurements of a Ducted and Unducted Rotor

Duct Spinning Mode's Particle Velocity Imaging with In-Duct Circular Microphone Array

Acoustic Imaging of a Duct Spinning Mode by the Use of an In-Duct Circular Microphone Array

Acoustic absorption and generation in ducts of smoothly varying area sustaining a mean flow and a mean temperature gradient

The Methodological and Experimental Research on the Identification and Localization of Turbomachinery Rotating Sound Source

Design of sinusoidal-shaped inlet duct for acoustic mode modulation noise reduction of cooling fan

Theoretical Model of Scattering from Flow Ducts with Semi-Infinite Axial Liner Splices

Theoretical Study of Sound Propagation in Lined Duct with Rigid Splices Using Wiener-Hopf Method

Sound Wave Scattering in a Flow Duct with Azimuthally Non-Uniform Liners

Acoustic pre-design studies of ducted fans for small aircraft

Theoretical Study and Numerical Validation of Sound Radiation from Coaxial Annular Duct

A hybrid finite element approach to modeling sound radiation from circular and rectangular ducts

An improved multimodal method for sound propagation in nonuniform lined ducts

Numerical simulation of sound propagation in and around ducts using thin boundary elements

Numerical study of the linear and non-linear damping in an acoustically forced cold-flow test rig with coupled cavities

Numerical study of acoustic radiation due to a supersonic turbulent boundary layer

Acoustic source characterization of simulated subsonic jet noise using spherical harmonics