Abstract:Radiative properties are critical to quantify radiative energy fluxes between surfaces and in participating media. However, there is limited experimental data on temperature-dependent radiative properties of materials. This work focuses on experimentally measuring temperature-dependent diffuse reflectance in the near- and mid-infrared spectra (1–20 μm) for ceramic particles with applications as heat-transfer and thermal-storage media in concentrated solar power (CSP) plants. Specifically, a commercially available sintered bauxite proppant, ACCUCAST ID80, and its primary chemical constituents—alumina (Al2O3) and silica (SiO2)—are measured in powder form using a Fourier transform infrared spectrometer (FTIR) coupled with a specialized diffuse reflectance accessory and a heated stage. Room-temperature diffuse reflectance measurements show increased absorption in tests with greater mass fractions of the ceramic samples. There is a strong correlation in the measured reflectance spectra of ACCUCAST with alumina and silica in the spectral range 2000–500 cm−1 (5–20 μm). Whereas, for shorter wavelengths (<5μm), the absorptance for ACCUCAST is greater than the absorptance for alumina and silica, indicating contributions from other chemical species present in the composite material. For the first time, temperature-dependent diffuse reflectance measurements are reported for ACCUCAST up to 1000 °C. These results are compared against those of alumina and silica through the calculation of a thermal emittance. All three materials exhibit a calculated emittance of ∼0.9 at room temperature. However, this value decreases to ∼0.6 for ACCUCAST and drops to less than 0.4 for alumina and silica at 1000 °C. Thermal cycling in air at 1000 °C resulted in a visible color change from dark grey to light orange for ACCUCAST and a subsequent larger increase in reflectance for wavelengths less than 5 μm as compared to ACCUCAST thermally cycled at 1000 °C in vacuum. Alumina and silica spectra proved to be largely unaffected by thermal cycling under atmospheric conditions. Overall, this study establishes a powerful technique for the characterization of radiative properties of particulate materials as a function of temperature and presents a detailed case study of ACCUCAST, a candidate for next-generation particle-based CSP.

EPR measurements of ceramic cores used in the aircraft industry

Investigation of Praseodymium Ions Dopant on 9/65/35 PLZT Ceramics' Behaviors, Prepared by the Gel-Combustion Route

Synthesis and Characterization of Doped Nano-Sized Ceria–zirconia Solid Solutions

X-ray Photoelectron Spectroscopy Analysis of Scandia-Ceria-Stabilized Zirconia Composites with Different Transport Properties

Microstructures And Pyroelectric Properties Of Multicomposition 0.9pbzro(3)Center Dot Xpbtio(3)Center Dot(0.1-X)Pb(Zn1/3nb2/3)O-3 Ceramics

Multi-Doped Zirconia Ceramic Probe for Fiber-Optic Contact Measurement of Ultra-High Temperatures in Oxidative Atmosphere

Sintering Behavior and Mechanical Properties of Alumina-Coated Zirconia Ceramics

High-temperature mass spectrometric study and modeling of ceramics based on the Al2 O3 -SiO2 -ZrO2 system

Investigation of High-Temperature Normal Infrared Spectral Emissivity of ZrO2 Thermal Barrier Coating Artefacts by the Modified Integrated Blackbody Method

Temperature-dependent diffuse reflectance measurements of ceramic powders in the near- and mid-infrared spectra

Improvements to pyroelectric ceramics via strontium doping of the lead zirconate-lead iron niobate-lead titanate system

Direct measurements of thermal transport in glass and ceramic microspheres embedded in an epoxy matrix

Thin-film Nano-Thermogravimetry Applied to Praseodymium-Cerium Oxide Films at High Temperatures

High‐temperature thermal conductivity measurement of porous ceramic coatings with a high heat flux CO2 laser rig

Measurement of Dielectric Properties of Pb(Zr0.52ti0.48)O3, Ba0.5sr0.5nb2o6, and Batio3 Ferroelectric Ceramics at Microwave Frequencies

Electron Magnetic Resonance Study of Ni50.2Mn28.3Ga21.5 Powders

Y-TZP ceramic processing from coprecipitated powders: a comparative study with three commercial dental ceramics

Effect of Ultrafine Powders Obtained by Mechanical Grinding on the Density of Ceramic Material Made of Aluminum and Zirconium Oxides

Preparation of Cepo4 Modified Zro2 Ceramics with Different Particle Sizes and Their Mechanical Behaviors

Growth and texture of Spark Plasma Sintered Al2O3 ceramics: a combined analysis of X-rays and Electron Back Scatter Diffraction

Ultrasonic Resonance Measuring for the Thickness of Ceramics Coatings