Autohydrolysis treatment of bamboo and potassium oxalate (K2C2O4) activation of bamboo product for CO2 capture utilization

Dang Duc Viet,Doan Thi Thao,Khuong Duy Anh,Toshiki Tsubota

DOI: https://doi.org/10.1007/s11705-024-2402-8

IF: 4.803

2024-03-04

Frontiers of Chemical Science and Engineering

Abstract:Typically, the hydroxide agents, such as sodium hydroxide and potassium hydroxide, which have corrosive properties, are used in the carbon activation process. In this study, potassium oxalate (K 2 C 2 O 4 ), a less toxic and non-corrosive activating reagent, was used to synthesize activated carbon from the solid residue after autohydrolysis treatment. The effect of the autohydrolysis treatment and the ratio of the K 2 C 2 O 4 /solid residue are presented in this study. Moreover, the comparison between the activated carbon from bamboo and biochar from the solid residue are also reported. The resulting activated carbon from the solid residue exhibited a high surface area of up to 1432 m 2 ·g −1 and a total pore volume of up to 0.88 cm 3 ·g −1 . The autohydrolysis treatment enhanced the microporosity properties compared to those without pretreatment of the activated carbon. The microporosity of the activated carbon from the solid residue was dominated by the pore width at 0.7 nm, which is excellent for CO 2 storage. At 25 °C and 1.013 × 10 5 Pa, the CO 2 captured reached up to 4.1 mmol·g −1 . On the other hand, the ratio between K 2 C 2 O 4 and the solid residue has not played a critical role in determining the porosity properties. The ratio of the K 2 C 2 O 4 /solid residue of 2 could help the carbon material reach a highly microporous textural property that produces a high carbon capture capacity. Our finding proved the benefit of using the solid residue from the autohydrolysis treatment as a precursor material and offering a more friendly and sustainable activation carbon process.

engineering, chemical