Abstract:The possibility of reusing ceramic roller waste to produce cordierite and mullite refractories was investigated. Five batches were designed using wastes representing ceramic roller waste, magnesite, and silica sand, shaped and fired at 1300 °C/2 h, and one batch was selected at 1200 °C. The chemical composition and precipitated phases of the used raw materials and the fired batches were analyzed using XRF and XRD techniques, respectively. Densification parameters, morphology, microstructure and electrical properties were also studied to evaluate the effect of the formed phases on the properties of fired materials. Bulk density increases with an increase in mullite and a decrease in cordierite, and it also increases with increasing temperature, whereas porosity and water absorption show a opposite behavior to density (it decreases with an increase in mullite and temperature). The main phases developed after firing at 1300 °C/2 h were cordierite, mullite, corundum, baddeleyite, and spinel. Bending strength increases with increasing mullite percentage and density, and decreasing grain size and porosity. The microstructure develops and becomes finer with increasing mullite percentage and density. The grain size of the crystals was very fine at 1200 °C/2 h and increased at 1300 °C/2 h. Broadband dielectric spectroscopy was employed to study the electrical and dielectric behavior of the investigated samples. The increase in mullite concentration shows a remarkable increase in ε', especially at lower frequencies, as it is three times higher than that of M10. At f > 103 Hz ε', frequency independence is accompanied by an increase in mullite concentrations due to the lag of dynamics fluctuations after the alteration of the electric field. The generation of new free ions leads to the enhancement of conductivity as the mullite concentration increases.

Mullite–zirconia composite for the bonding phase of refractory bricks in hazardous waste incineration rotary kiln

Thermal decomposition and reaction sintering for synthesis of mullite-zirconia composite using kaolin, γ-alumina and zirconia

Enhanced performance of low-carbon MgO–C refractories with nano-sized ZrO2–Al2O3 composite powder

Controlling the Thermal Stability of Kyanite-Based Refractory Geopolymers

Process Development of Zirconolite Ceramics for Pu Disposition: Use of a CuO Sintering Aid

Advanced Solid Geopolymer Formulations for Refractory Applications

Synthesis and characterization of ceramic refractories based on industrial wastes

Microstructure evolution, mechanical characteristics and erosion behavior of Cr2O3–Al2O3–MgO–ZrO2 refractories in molten reduction slag

Preparation and Properties of Lightweight Aggregates from Discarded Al2O3-ZrO2-C Refractories

Synthesis of mullite from wasted silica brick, wasted fireclay brick and wasted slide gate

Thermal shock behavior of andalusite‐based refractories: Microstructural investigation of crack bridging and grain‐matrix interactions

Low-cost northern Tunisian kaolinitic clay-based refractory materials and effect of a rich alumina clay addition

Composition and microstructure of a periclase–composite spinel brick used in the burning zone of a cement rotary kiln

Microstructure, phase evolution, mechanical properties and slag corrosion resistance of ZrO2 reinforced Al2O3–Cr2O3 composites

Fluoride-immobilized co-processing and resource utilization of aluminum-electrolyzed spent cathode carbon in brick-fired kiln

Production of pyroxene ceramics from the fine fraction of incinerator bottom ash

Alumina–zirconium ceramics synthesis by selective laser sintering/melting

Reaction mechanisms and properties of in situ porous Al2O3-ZrO2-mullite composites

High-temperature performance in Al2O3–Cr2O3 refractories: Effect of Al2TiO5

Preparation and thermal shock resistance investigation of ZTA-La 2 O 3 composite ceramics for porous medium combustion materials

The influence of zirconium dioxide nanoadditives on the properties of mullite-corundum