Abstract:We report on measurements and modeling studies performed from 2021 to 2024 on the 76 sextupole magnets in the Cornell Electron-positron Storage Ring CESR. Beam-based, magnet-specific calibrations ($K_2$ value versus excitation current) were measured. It was found that the new calibrations differ from those previously in use by an average of 3.1% with an RMS spread of 12%. The uncertainties in the calibration correction factors average 1.7% with an RMS spread of 1.0%. Sextupole alignment values relative to the reference orbit were measured by combining the measured beam position with the quadrupole and skew quadrupole terms caused by a sextupole strength change $\Delta K_2$. High accuracy was achieved by fitting to difference phase and coupling functions as $K_2$ was varied. The horizontal (vertical) average offset values were found to be -0.01 (0.03)~mm with RMS spread of 1.1 (0.9)~mm with some exceptionally large values of a few millimeters. Typical uncertainties are 0.01-0.02~mm. The above measurements were motivated by the precision required in measuring horizontal beam size at each sextupole. A precision of 10\% for a \mbox{1-mm} beam size requires uncertainties of better than 0.1~$\mu$radian in the horizontal angle change produced in the sextupole for a typical strength change of \mbox{$\Delta K_2 \, L$ = 1 m$^{-2}$}, where $L$ is the length of the sextupole, as well as 10\% in the difference of the squared horizontal and vertical beam positions relative to the center of the sextupole. These precision values were achieved by the analysis of difference functions. However, a small source of horizontal angle change of unknown origin, independent of the sextupole strength, requires a sextupole strength range larger than now available to measure accurately the typical horizontal beam size at CESR.

Measurement and Compensation of Horizontal Crabbing at the Cornell Electron Storage Ring Test Accelerator

A method of bunch by bunch measurement at nanoseconds interval by using cavity beam position monitors

Study of the Crosstalk Evaluation for Cavity BPM

In situ beam trajectory tilt measurement based on single cavity beam position monitor

Optimization of the Cavity Beam-Position Monitor System for the Shanghai Soft X-ray Free-Electron Laser User Facility

Instrumentation for the Study of Low Emittance Tuning and Beam Dynamics at CESR

Lattice design and experimental studies of nonlinear resonance at the Cornell Electron Storage Ring

Measurement and modeling of electron cloud in a field free environment using retarding field analyzers

Error Determination in Sextupole Magnet Calibration and Alignment Measurements and Application to Horizontal Beam Size Calculations at the Cornell Electron-positron Storage Ring

Measurement and modeling of electron-cloud-induced betatron tune shifts at the Cornell Electron-positron Storage Ring test accelerator

Beam-beam simulation with crab-cavities for eRHIC

Coupled beam motion in a storage ring with crab cavities

Experimental Study of Synchro-Betatron Coupling Induced by Dipole Modulation

The Conversion of CESR to Operate as the Test Accelerator, CesrTA, Part 4: Superconducting Wiggler Diagnostics

Optimization and Measurement for an Electron Side-Coupled Linac with Longitudinally Off-Axis Coupling Cavities

Simulation and measurement of the interplay between electron cooling, impedance, intrabeam scattering, and space charge for coasting beams

Measurement of Electron Trapping in the Cornell Electron Storage Ring

HIGH Q CAVITIES FOR THE CORNELL ERL MAIN LINAC

Higher-order mode-based cavity misalignment measurements at the free-electron laser FLASH

Measuring and Controlling the Energy Spread in CEBAF

Visible-light beam size monitors using synchrotron radiation at CESR