Abstract:Whichever the application field, every material forming process generates residual stresses on the surface. While they are likely to enhance the aimed properties of the final mechanical part, these stresses may also drastically reduce them and result in early failures. Therefore, understanding the residual stress state remains a major challenge when coating complex parts, especially as most characterization methods at the microscopic scale involve specific sample preparation procedures which may affect the residual stresses field. This work investigates the residual stress state that exists in chromium oxide coatings deposited via Atmospheric Plasma Spray (APS), using two pioneering techniques featuring high spatial resolution: Scanning Microwave Microscopy and Raman MicroSpectroscopy. The first technique combines the measurement of microwave electromagnetic capacities of a Vector Network Analyzer with the subnanometric resolution of an Atomic Force Microscope: it thus enables performing depth investigations at very accurately defined positions of the probe on the surface. The second technique relies on the principle of photons inelastic scattering and involves a laser beam aiming at the material sample: it allows a fine characterization of the microstructure as well as defects and stresses detection via molecular vibratory signatures. The investigation scale is limited here to a few cubic micrometers. Due to the highly localized scales of our investigations, which also depend on the device, the objective of our procedure required that the comparison should be made not on individual points but on definite mapped areas, every spot being analyzed and post-treated one after another, with optimum measuring parameters. Results have been correlated with XRD measurements to cross-check the average amount of stress observed over a wider area.

XPS on corrosion products of ZnCr coated steel: on the reliability of Ar+ ion depth profiling for multi component material analysis

Surface composition and depth profile analysis of sulphate and chloride-based trivalent chromium electrodeposits using X-ray photoelectron spectroscopy

Effects of Sputtering on XPS Depth Profile Analysis of Zirconium-based Chemical Conversion Coatings

XPS depth profiling of nano-layers by a novel trial-and-error evaluation procedure

Application of grazing incidence wide-angle X-ray scattering to characterise mechanically plated coatings

Accurate high-resolution depth profiling of magnetron sputtered transition metal alloy films containing light species: A multi-method approach

Acta Polytechnica

Application of Small- and Ultra-Small-Angle Neutron Scattering for the Characterization of Mechanically Plated Coatings

Application of the analytical methods REM/EDX, AES and SNMS to a chlorine induced aluminium corrosion

Combining AFM imaging and elementally resolved spectro-electrochemistry for understanding stability and quality of passive films formed on Alloy 600

X-Ray Photoelectron Spectroscopy Estimation of Cobalt Seed Layer Reactivity Toward Air Exposure: A Challenge?

Corrosion Monitoring On Zinc Electroplated Steel Using Shortwave Infrared Hyperspectral Imaging

Sub‐Nanometer Depth Profiling of Native Metal Oxide Layers Within Single Fixed‐Angle X‐Ray Photoelectron Spectra

XPS for non-destructive depth profiling and 3D imaging of surface nanostructures

Investigation of the X‐ray fluorescence technique in the characterization of Ni coatings applied to historical heritage studies

X-ray photoelectron spectroscopy of high-throughput mechanically exfoliated van der Waals materials

Contributions to a More Realistic Characterization of Corrosion Processes on Cut Edges of Coated Metals Using Scanning Microelectrochemical Techniques, Illustrated by the Case of ZnAlMg-Galvanized Steel with Different Coating Densities

An Obliquely Incident X-Ray Radiography to Measure Greatest Corrosion Depths in Automobile Metallic Plates

Depth Profiling of Thin Films with Pulsed Glow Discharge Atomic Emission Spectrometry

In situ XRD measurements to explore phase formation in the near surface region

Characterisation of the galvanic protection of zinc flake coating by spectroelectrochemistry and industrial testing