Abstract:<p>Hydrocarbon exploration is extending from the shallowly buried to deeply buried strata with increasing demands for fossil fuels. The variable storage and percolation capacities that intrinsically depend on the pore geometry restrict the hydrocarbon recovery and displacement efficiency and trigger studies on the micro-scale pore structure, fluid flow capacity, and their controlling factors. Minerals within sandstone are the results of the coupling control of depositional factors and diagenetic alternations, which determine the microscopic pore geometry and subsequently affect the fluid flow capacity. In order to investigate the impacts of mineralogy on the pore structure and fluid flow capacity, integrated analyses including porosity and permeability measurements, casting thin section (CTS), scanning electron microscopy (SEM), pressure-controlled mercury porosimetry (PCP), rate-controlled mercury porosimetry (RCP), nuclear magnetic resonance (NMR), and X-ray diffraction (XRD) are conducted on the deeply buried sandstone samples in the Jurassic Sangonghe Formation of the Junggar Basin. Microscopic pore structure is characterized by the combination of SEM, CTS, PCP, and RCP and fractal theory. Fluid flow capacity is evaluated by the innovative application of film bound water model in NMR and mineralogy is quantitatively measured by XRD. The results indicate that the deeply buried sandstone is rich in quartz (54.2%), feldspar (25.1%), and clay (14.2%), with dominant kaolinite (5.04%) and chlorite (5.38%) cementation. The reservoir has a wide pore-throat diameter distribution with three peaks in the ranges 0.01&#8211;1, 10&#8211;80, and 200&#8211;1000 &#956;m. Pores are tri-fractal and can be divided into micropores, mesopores, and macropores, with average porosity contributions of 50.11, 21.83, and 28.04%, respectively. The movable porosity of deeply buried sandstone ranges from 1.75 to 8.24%, primarily contributed by intergranular (avg. 2.34%) and intragranular pores (avg. 2.56%). Most of the fluids are movable in intergranular pores but are irreducible in intragranular pores. Correlation analyses between mineralogy and pore structure suggest that quartz provides preservation to intergranular porosity, which increases pore size and macropores porosity and reduces heterogeneity of the pore system. The influence of feldspar reverses and becomes poor owing to the simultaneous clay precipitation and complex roles of feldspar dissolution in microporosity. Chlorite, kaolinite, and illite, all act as destructions to intergranular porosity. They enhance the mesopores and micropores porosities, reduce the pore size, and increase the microscopic heterogeneities of the macropores, micropores, and whole pore system. The relationships between mineralogy and fluid flow capacity indicate that quartz is favorable for the fluid flow capacity, but feldspar and clay play negative roles. The reversed impacts of quartz and feldspar lay in their opposite controls on pore size. However, both pore size and hydrophilia should be taken into account when considering the effects of clay minerals. These negative effects are associated with types, contents, and hydrophilic degrees of clay minerals, in which I/S and illite exhibit the strongest negative impacts. The fluid flow in the intergranular and intragranular pores is generally enhanced by higher quartz content, but reduced by higher clay content. Irreducible fluids in the intergranular and intragranular pores are determined by chlorite and kaolinite contents, respectively.</p>

Influence of quartz types on rock fabrics and bulk physical properties in organic-rich mudstone: A review

Quartz types, silica sources and their implications for porosity evolution and rock mechanics in the Paleozoic Longmaxi Formation shale, Sichuan Basin

Quartz Types, Formation Mechanism, and Its Effect on Shale Oil and Gas Enrichment: A Review

Influence of quartz types on mechanical parameters in the early silurian Longmaxi shale, Sichuan Basin

Quartz types, genesis and their geological significance within the Wufeng-Longmaxi Formation in north-western Hunan, China

Quartz Cement and Its Origin in Tight Sandstone Reservoirs of the Cretaceous Quantou Formation in the Southern Songliao Basin, China

The impact of silica diagenesis on shale rock mechanical properties: An example from the upper ordovician-lower silurian wufeng-longmaxi formations, Southeast Sichuan Basin, South China

Grain-scale Petrographic Evidence for Distinguishing Detrital and Authigenic Quartz in Shale: How Much of a Role Do They Play for Reservoir Property and Mechanical Characteristic?

SEM/EBSD analysis of quartz cementation and compaction microstructures during diagenesis of sandstone

Source of quartz cement in tight gas sandstone: Evidence from the Upper Triassic Xujiahe Formation in the western Sichuan Basin, SW China

Quantifying Young's Modulus of Mudstone after Water Immersion: Insights from the Mechanical Properties of Micro-Mineral Compositions

Unraveling mudstone compaction at microscale: A combined approach of nanoindentation mapping and machine learning data analysis

Impacts of mineralogy on micro-scale pore structure and fluid flow capacity of deeply buried sandstone reservoirs

Investigation of Mechanical Properties of Quartz and Illite in Shale Using Molecular Dynamics Simulation

A little mica goes a long way: Impact of phyllosilicates on quartz deformation fabrics in naturally deformed rocks

Origin and significance of authigenic quartz and albite in lacustrine calcareous fine-grained sedimentary rocks

Multi-Scale Quantitative Characterization of Pore Distribution Networks in Tight Sandstone by Integrating FE-SEM, HPMI, and NMR with the Constrained Least Squares Algorithm

Influence of Organic Matter on Smectite Illitization: A Comparison Between Red and Dark Mudstones from the Dongying Depression, China

Advances in Microscopic Pore Structure Characterization of Fine-Grained Mudrocks

Effect of Fabric Factors on the Mechanical Behavior of Foliated Rocks: A Particle Flow Approach

Rock Fabric of Lacustrine Shale and Its Influence on Residual Oil Distribution in the Upper Cretaceous Qingshankou Formation, Songliao Basin