A study on mechanisms of saw-tooth chip formation in hard turning under hybrid nanofluid-assisted MQL environment

Tran Minh Duc,Tran Bao Ngoc,Ngo Minh Tuan,Dang Thi Huyen Trang,Tran The Long
DOI: https://doi.org/10.1177/16878132241289286
IF: 2.1
2024-10-30
Advances in Mechanical Engineering
Abstract:Advances in Mechanical Engineering, Volume 16, Issue 10, October 2024. Saw-tooth chip generated from hard turning is one of the most distinguishing features with conventional turning process. The presented work aims to contribute an extensive understanding the formation mechanism and main parameters of saw-tooth chips in oblique hard turning of 90CrSi hardened tool steel (60–62 HRC). The effects of dry, Al2O3 nanofluid MQL, Al2O3/MoS2 hybrid nanofluid MQL conditions on the serrated chip formation were experimentally investigated in terms of chip morphology, chip color, segment spacing, serrated segmentation frequency, and shear angle. The obtained experimental results indicated that, due to the better cooling and lubricating performance of nanofluid and hybrid nanofluid, the shear angles φ increase about 91.73% and 94.88% respectively when compared to dry cutting, which makes the formation of saw-tooth chip more favorable. Moreover, the analysis of microstructure image of the back side of chip proves the better lubrication from ball roller and tribo-film formation of Al2O3 and MoS2 nanoparticles. Based on the chip morphology analysis, the shear angle φ, the degree of chip segmentation on the top side in the chip's transverse section K2, and the chip deformation coefficient in the transverse section K3 should be used as the additional criterions to evaluate the frictional improvement in cutting zone.
engineering, mechanical,thermodynamics
What problem does this paper attempt to address?