Abstract:In this study we synthesized LiFePO4/carbon/reduced graphene oxide (LFP/C/rGO) composite cathode materials using a method involving sol–gel processing, spray-drying, and calcination. To improve the electrochemical performance of LFP/C, we tested graphene oxides (GOs) of various morphologies as conductive additives, including pristine GO, three-dimensional GO, and hydrothermal porous GO (HTGO). Among our samples, the cathode material prepared through spray-drying with the addition of 1 wt% of HTGO (denoted SP-LFP/C/1%rHTGO) displayed the best electrochemical performance; its discharge capacities at 0.1C, 1C, 5C, and 10C were 160.5, 151.8, 138.8, and 130.3 mA h g−1, respectively. From measurements of its long-term cycling performance, the discharge capacity in the first cycle and the capacity retention after 30 cycles at 0.1C were 160.2 mA h g−1 and 99.6%, respectively; at 10C, these values were 132.2 mA h g−1 and 91.8%, respectively. The electronic conductivity of SP-LFP/C/1%rHTGO (6.58 × 10−5 S cm−1) was higher than that of the pristine LFP/C (9.24 × 10−6 S cm−1). The Li+ ion diffusivities (DLi+) of the SP-LFP/C/1%HTGO cathode, measured using AC impedance (3.91 × 10−13 cm2 s−1) and cyclic voltammetry (6.66 × 10−10 cm2 s−1 for discharge), were superior to those of the LFP/C cathode (9.31 × 10−15 cm2 s−1 and 1.79 × 10−10 cm2 s−1 for discharge, respectively). Galvanostatic intermittent titration revealed that the value of DLi+ was located in a reasonable range from 1 × 10−10 to 1 × 10−17 cm2 s−1; its value dropped to its lowest point when the state of charge was close to 50%. Thus, the use of spray-drying and the addition of conductive HTGO (having a 3D wrinkled morphology and interconnected pore structure) can enhance the electronic conductivity and Li+ ion diffusivity of LFP/C cathode materials, thereby improving the electrochemical performance significantly.

Research based on graphene oxide composite with LiFe0.97Ni0.03PO4

A Reduced Graphene Oxide/sno2/polyaniline Nanocomposite for the Anode Material of Li-ion Batteries

Fe 3 O 4 /graphene Composites with a Porous 3D Network Structure Synthesized Through Self-Assembly under Electrostatic Interactions As Anode Materials of High-Performance Li-Ion Batteries

Reduced Graphene Oxide Coating LiFePO4 Composite Cathodes for Advanced Lithium-Ion Battery Applications

Optimization of NiFe2O4/rGO Composite Electrode for Lithium-Ion Batteries

Modifying the morphology and structure of graphene oxide provides high-performance LiFePO4/C/rGO composite cathode materials

Synergistic Ternary Composite (carbon/fe3 O4 @graphene) with Hollow Microspherical and Robust Structure for Li-Ion Storage.

Synthesis and Properties of LiFePO4/LiNi0.8Co0.15Al0.05O2 Composite Cathode Material Modificated by Graphene for Lithium Ion Battery

Improvement in Electrochemical Performance of Calcined LiNi0.5Mn1.5O4/GO

Synthesis and characterization of LiMn0.8Fe0.2PO4/rGO/C for lithium-ion batteries via in-situ coating of Mn0.8Fe0.2C2O4·2H2O precursor with graphene oxide

Nickel catalyzed graphitized carbon coated LiFe1-xNixPO4 composites as cathode material for high-performance lithium-ion batteries

The Reduced Graphene Oxide Conductive Additives with a Certain Defect Concentration Enabling Rate-Capability of Lithium-Ion Batteries

Graphene-Based Materials for Lithium-Ions Batteries

In-situ and Selectively Laser Reduced Graphene Oxide Sheets As Excellent Conductive Additive for High Rate Capability LiFePO4 Lithium Ion Batteries

Improving the electrochemical properties of lithium iron(II) phosphate through surface modification with manganese ion(II) and reduced graphene oxide

Facile preparation of cellulose nanofiber derived carbon and reduced graphene oxide co-supported LiFePO4 nanocomposite as enhanced cathode material for lithium-ion battery

Composites of Reduced Graphene Oxide and Fe 2 O 3 Nanoparticles Anchored on MoS 2 Nanosheets for Lithium Storage

Surface Modification of Nanocrystalline LiMn2O4 Using Graphene Oxide Flakes

Design of Nb2O5@rGO composites to optimize the lithium-ion storage performance

Preparation, Lithium Storage Performance and Thermal Stability of Nickel‐Rich Layered LiNi0.815Co0.15Al0.035O2/RGO Composites

Loading Fe3O4 nanoparticles on N, S co-doped graphene suppressing polysulfides conversion toward high-performance Li–S batteries