Abstract:Impact of airborne particles on convective mass transfer coefficient (h(m)) of semivolatile organic compounds (SVOCs) at flat surfaces has been investigated by assuming gas-particle equilibrium partition. In realistic indoor environments, however, this equilibrium partition might not be attained because the time required to reach equilibrium could be longer than residence time of airborne particles. No quantitative result of influence of particles on h(m) under a non-equilibrium state has been given yet. A mass transfer model was used in this study to quantify this influence for the laminar air flow. The influence, calculated as ratio of hm with particles present to h(m) with particles absent, epsilon, was found to significantly depend on three dimensionless parameters: Bi-p, R, and C-p(*)(infinity). Bi-p represents the ratio of mass transfer rate between gas- and particle-phases SVOCs to mass transfer rate of gas-phase SVOCs transporting across the concentration boundary layer, R is the ratio of SVOC mass in particle-phase to that in gas phase at equilibrium state, and C-p(*)(infinity) characterizes non-equilibrium degree of particle-phase SVOCs in the bulk air (higher non-equilibrium degree as it deviates further away from one, as one corresponds to equilibrium). At equilibrium state (C-p(*)(infinity) = 1), the presence of particles enhances h(m) (epsilon > 1) to the same extent for source surfaces and sink ones. At non-equilibrium state, epsilon varies linearly as C-p(*)(infinity) changes (C-p(*)(infinity) > 1 for source surface, and C-p(*)(infinity) < 1 for sink surface). The presence of particles always enhances hm for SVOC source surfaces. In contrast, it can either enhance (epsilon > 1) or weaken (0 < epsilon < 1) h(m) for sink surfaces, depending on non-equilibrium degree between gas-phase SVOCs and particles (characterized by C-p(*)(infinity)). An empirical formula relating epsilon with these three parameters was obtained. Good agreement between predictions by the formula and experimental results in the literature moderately supported its reliability. Results of this study could be useful in better estimating indoor SVOC concentrations, as well as assessing and controlling human exposure to indoor SVOCs. (C) 2017 Elsevier Ltd. All rights reserved.

Overall mass transfer coefficient for pollutant emissions from small water pools under simulated indoor environmental conditions

Henry's law constant and overall mass transfer coefficient for formaldehyde emission from small water pools under simulated indoor environmental conditions

Influence of Airborne Particles on Convective Mass Transfer of SVOCs on Flat Surfaces: Novel Insight and Estimation Formula

Understanding and Controlling Airborne Organic Compounds in the Indoor Environment: Mass Transfer Analysis and Applications

Reactive uptake coefficients for multiphase reactions determined by a dynamic chamber system

Computational fluid dynamics analysis of a micro-scale chamber for measuring organic chemical emission parameters

Henry’s Law Constants and Indoor Partitioning of Microbial Volatile Organic Compounds

Modeling exposure close to air pollution sources in naturally ventilated residences: association of turbulent diffusion coefficient with air change rate

A mass transfer model for simulating volatile organic compound emissions from ‘wet’ coating materials applied to absorptive substrates

Two-phase hydrodynamics and aerosol mass transfer characterization in pool scrubbing: A simultaneous measurement technique

A Mass Transfer Model to Predict the Performance of Tube-type Passive Samplers for Exposure Determination of Volatile Organic Compounds

Simplifying Analysis of Sorption of SVOCs to Particles: Lumped Parameter Method and Application Condition

Size-Resolved Surface Deposition And Coagulation Of Indoor Particles

Aerosol dynamics modeling of sub-500 nm particles during the HOMEChem study

A Review Of Mass-Transfer Models And Mechanistic Studies Of Semi-Volatile Organic Compounds In Indoor Environments

Simulation of residential indoor PM2.5 concentration and model validation

Mathematical Model Research Of Mass Transfer Across Water-Air Interface For Volatile Poisons

A Novel Method for Measuring the Diffusion, Partition and Convective Mass Transfer Coefficients of Formaldehyde and VOC in Building Materials

An improved mass transfer based model for analyzing VOC emissions from building materials

Simplified methods for characterizing dynamic sorption of SVOCs on viscous particles

Emission Rates Due to Indoor Activities: Indoor Aerosol Model Development, Evaluation, and Applications