Abstract:It is highly imperative to recover energy from not only the lipid fraction of microalgae but also the residual biomass after lipid-extraction to augment energy potential and to facilitate the sustainability of algal-based bioenergy. Herein, we present the production of syngas from microalgae residual biomass (Chlorella vulgaris), upon its extraction as by-product from biodiesel production system, in a lab-scale fixed bed reactor (FBR). The influences of two gasification parameters such as temperature (700, 800 and 900 degrees C) and catalysts type (Y2O3, Ni and eggshell derived CaO) have been studies in terms of CnHm/CO/H-2 gas yield and composition, carbon conversion efficiency (CCE%), lower heating value (LHV) of syngas under 5% O-2 and 95% Ar gasification environment. From the results, 800 degrees C was found to be an optimum temperature producing highest H-2 yield (4.53 mmol g(-1) biomass with purity of 34.62 vol%) and highest generation peak intensity of 0.14 mmol min(-1) g(-1), whereas highest LHV (8.92 MJ N m(-3)), total gas yield (73.54 wt%) and CCE (49.54%) were obtained at 900 degrees C. Addition of catalysts further improved H-2 yield and its volume fraction, total gas yield and CCE%. The Ni catalyst was found to be the most effective catalyst in terms of the maximum H-2 yield (8.22 mmol g(-1) biomass with purity of 56.12 vol%), highest total gas yield of 80.21 wt%, and CCE of 49.06% owing to its relatively high catalytic activity for promoting water-gas shift, as well as tar and char reforming reactions. The average LHV of syngas was obtained to be 9 MJ N m(-3). Furthermore, the considerable decrease in tar and char contents from 20.12 wt% and 21.77 wt% (without catalyst at 700 degrees C) to 9.32 wt% and 10.47 wt% (with Ni catalyst) was recorded.

The rationale for pulse oximetry and capnometry in anaesthesia and sedation.

Hydrothermal Carbonization of Cellulose and Xylan into Hydrochars and Application on Glucose Isomerization

Catalytic Fast Pyrolysis of Cellulose in a Microreactor System Using Hierarchical Zsm-5 Zeolites Treated with Various Alkalis

Study on the Pyrolysis of Cellulose for Bio-Oil with Mesoporous Molecular Sieve Catalysts.

[Influence of ZSM-5(38)/Al-MCM-41 Composite Molecular Sieve Catalysts on Pyrolysis of Cellulose].

Enhanced Hydrogen Production by the Catalytic Alkaline Thermal Gasification of Cellulose with Ni/Fe Dual-Functional CaO Based Catalysts

CO Rich Syngas Production from Catalytic CO2 Gasification-Reforming of Biomass Components on Ni/CeO2

A Cellulose Electrolysis Cell with Metal-Free Carbon Electrodes

Enhancing syngas production and hydrogen content in syngas from catalytic slow pyrolysis of biomass in a pilot scale fixed bed reactor

Synergistic benefits for hydrogen production through CO2-cofeeding catalytic pyrolysis of cellulosic biomass waste

Investigation of Catalysts, CO2 Sorbents and Their Combinations for Maximising H2 Output During the Thermal Decomposition of Biomass

Catalytic Pyrolysis of Microcrystalline Cellulose with Five Molecular Sieve Based Catalysts in Py-GC-MS

Experimental Research on Catalyzed Hydrothermal Gasification of Cellulose

Enhancing ketones and syngas production by CO2-assisted catalytic pyrolysis of cellulose with the Ce–Co–Na ternary catalyst

Gasification of Algal Residue for Synthesis Gas Production

Catalytic pyrolysis of biomass for biofuels production

Gas and Liquid Fuel Production from Non-edible/Unutilized Biomass by Catalytic Conversion

Light Promotion and Different Reaction Pathways Enhance Photothermocatalytic Syngas Production for Cellulose Steam Reforming Over Ni/θ‐Al2O3

Development of Photothermal Catalyst from Biomass Ash (Bagasse) for Hydrogen Production via Dry Reforming of Methane (DRM): An Experimental Study

Catalytic conversion of lignocellulosic biomass to fine chemicals and fuels

Catalytic pyrolysis of biomass components over mesoporous catalysts using Py-GC/MS