Abstract:For a remote sensing pixel with 3D surface, the directionality of thermal emission depends on the component parameters of the pixel, such as component temperatures, component emissivities and structural parameters. The contribution of the multiple scattering between components to the directional thermal emission is mainly affected by the 3D structure of pixel. In this paper, we present an analytical model to describe the multiple scattering between components and its contribution to the pixel's emission. The modeling work is based on the conceptual geometric-optical thermal emission model. For the non-isothermal pixel with random distributed components, at the pixel's scale, the openness coefficient and viewing factor is defined, the effect of multiple scattering between components is modeled with the principle of multiple bouncing. Then the directional thermal emission of pixel is derived based on the areal weighted emission of components by taking the ambient radiation into account. The model is validated using measurement data indoor. The two experimental data sets are on different observing object (samples of pingpong spheres and simulated trees made of cotton). Each set of measurement data includes directional thermal emission of pixel, the emission of components, the ambient thermal radiance, and the structural parameters of the pixel. These measured data of components are as input of the model, the brightness temperature of the pixel is calculated. The model predicted brightness temperatures and their comparison with the measured brightness temperature in pixel scale are presented in the paper. The directionality of the effect of multiple scattering is also discussed. The result demonstrates that in pixel scale the analytical model prediction fits the measurement well. Note that in the multiple scattering effect model, when the samples on the background are very close to each other and the viewing facrot VF 2-2can not be ignored, our modeling methodology can still apply. But the results formula will then be very complicated. In such case, a two layer multiple bouncing model would be more appropriate.

Analysis of Crosstalk Effect in Multi-Pixel Thermopile Sensors With Networked Arrangement

Analysis of Polarization Error of Sensors Based on Michelson Interferometer

The Photon Detection Mode of Photomultiplier Tubes Considering the Pulse Height Distribution

The Linearity Analysis of Different Two Dimensional Position Sensitive Detectors with Different Structure by Using Multisim

A Thermal Network Model for Multichip Power Modules Enabling to Characterize the Thermal Coupling Effects

Signatures of Thermal and Electrical Crosstalk in a Microwave Multiplexed Hard X-ray Transition Edge Sensor Array

Measurement errors in the scanning of resistive sensor arrays

The Analysis Of Electron Scattering Among Multiplying Layer In Ebaps Using Optimized Monte Carlo Method

Characterization and analysis of electrical crosstalk in a linear array of CMOS image sensors

Thermal Crosstalk Modelling and Compensation Methods for Programmable Photonic Integrated Circuits

MOS-based model of four-transistor CMOS image sensor pixels for photoelectric simulation

Crosstalk in CMOS Terahertz Detector Array with On-Chip SPR Antenna

An Analytical Model for Studying the Structural Effects and Optimization of A Capacitive Tactile Sensor Array

Analysis on the crosstalk saturation phenomenon of CCD during the detecting process

Modeling and Analysis of Crosstalk for Time-Interleaved Photonic ADCs

Time-dependent crosstalk effects for image sensors with different isolation structures

Analytical Modeling of Charge Behavior in Pinned Photodiode for CMOS Image Sensors

An Analytical Thermal Emission Model on the Effect of Multiple Scattering for 3-D Structural Pixel and the Model Validation

Combining TCAD and Monte Carlo Methods to Simulate CMOS Pixel Sensors with a Small Collection Electrode using the Allpix Squared Framework

High Accuracy Approach for Crosstalk Effects Compensation on 2-D Resistive Sensor Array Readouts