Abstract:In this paper, the memristive switching behavior of Cu/ HfO2/p++ Si devices fabricated by an organic-polymer-assisted sol-gel spin-coating method, coupled with post-annealing and shadow-mask metal sputtering steps, is examined. HfO2 layers of about 190 nm and 80 nm, are established using cost-effective spin-coating method, at deposition speeds of 2000 and 4000 rotations per minute (RPM), respectively. For two types of devices, the memristive characteristics (Von, Ion, and Vreset) and device-to-device electrical repeatability are primarily discussed in correlation with the oxide layer uniformity and thickness. The devices presented in this work exhibit an electroforming free and bipolar memory-resistive switching behavior that is typical of an Electrochemical Metallization (ECM) I-V fingerprint. The sample devices deposited at 4000 RPM generally show less variation in electrical performance parameters compared to those prepared at halved spin-coating speed. Typically, the samples prepared at 4000 RPM (n = 8) display a mean switching voltage Von of 3.0 V (±0.3) and mean reset voltage Vreset of -1.1 V (±0.5) over 50 consecutive sweep cycles. These devices exhibit a large Roff/Ron window (up to 104), and sufficient electrical endurance and retention properties to be further examined for radiation sensing. As they exhibit less statistical uncertainty compared to the samples fabricated at 2000 RPM, the devices prepared at 4000 RPM are tested for the detection of soft gamma rays (emitted from low-activity Cs-137 and Am-241 radioactive sources), by assessing the variation in the on-state resistance value upon exposure. The analysis of the probability distributions of the logarithmic Ron values measured over repeated ON-OFF cycles, before, during and after exposing the devices to radiation, demonstrate a statistical difference. These results pave the way for the fabrication and development of cost-effective soft-gamma ray detectors.

Drop-coated Titanium Dioxide Memristors

The effect of changing electrode metal on solution-processed flexible titanium dioxide memristors

A low-cost memristor based on titanium oxide

Filamentary Extension of the Mem-Con theory of Memristance and its Application to Titanium Dioxide Sol-Gel Memristors

Active Memristive Layer Deposition via Mn(II)-Assisted Anodic Oxidation of Titanium

All-Printed Flexible Memristor with Metal–Non-Metal-Doped TiO2 Nanoparticle Thin Films

Bipolar Cu/HfO2/p++ Si Memristors by Sol-Gel Spin Coating Method and Their Application to Environmental Sensing

Nonvolatile resistive switching memory behavior of the TiOx-based memristor

Electrolyte Influence on Properties of Ultra-Thin Anodic Memristors on Titanium

Carrier transport mechanism and bipolar resistive switching behavior of a nano-scale thin film TiO2 memristor

High performance, electroforming-free, thin film memristors using ionic Na 0.5 Bi 0.5 TiO 3

Resistive switching and synaptic learning performance of a TiO2 thin film based device prepared by sol–gel and spin coating techniques

Self-rectifying TiOx-based memristor with synaptic plasticity

"Optimizing Deposition Parameters and Characterizing TiO2 Thin Films for Future Memristor Applications"

Resistive switching phenomena in TiOx nanoparticle layers for memory applications

Electrochemical anodic oxidation assisted fabrication of memristors

Truly Electroforming‐Free Memristor Based on TiO 2 ‐CoO Phase‐Separated Oxides with Extremely High Uniformity and Low Power Consumption

Facile Hydrothermal Synthesis and Resistive Switching Mechanism of the α-Fe2O3 Memristor

Interfacial reaction induced digital-to-analog resistive switching in TiO2-based memory devices

Analog programming of CMOS-compatible Al$_2$O$_3$/TiO$_\textrm{2-x}$ memristor at 4.2 K after metal-insulator transition suppression by cryogenic reforming

Research on Electronic Synaptic Simulation of HfO2-based Memristor by Embedding Al2O3