Abstract:Owing to their intrinsic (geometry dependent) radiation hardness, 3D pixel sensors are promising candidates for the innermost tracking layers of the forthcoming experiment upgrades at the Phase 2 High-Luminosity LHC (HL-LHC). To this purpose, extreme radiation hardness up to the expected maximum fluence of 2e16 <a class="link-external link-http" href="http://neq.cm" rel="external noopener nofollow">this http URL</a>-2 must come along with several technological improvements in a new generation of 3D pixels, i.e., increased pixel granularity (50x50 or 25x100 um2 cell size), thinner active region (~100 um), narrower columnar electrodes (~5 um diameter) with reduced inter-electrode spacing (~30 um), and very slim edges (~100 um). The fabrication of the first batch of these new 3D sensors was recently completed at FBK on Si-Si direct wafer bonded 6-inch substrates. Initial electrical test results, performed at wafer level on sensors and test structures, highlighted very promising performance, in good agreement with TCAD simulations: low leakage current (<1 pA/column), intrinsic breakdown voltage of more than 150 V, capacitance of about 50 fF/column, thus assessing the validity of the design approach. A large variety of pixel sensors compatible with both existing (e.g., ATLAS FEI4 and CMS PSI46) and future (e.g., RD53) read-out chips were fabricated, that were also electrically tested on wafer using a temporary metal layer patterned as strips shorting rows of pixels together. This allowed a statistically significant distribution of the relevant electrical quantities to be obtained, thus gaining insight into the impact of process-induced defects. A few 3D strip test structures were irradiated with X-rays, showing inter-strip resistance of at least several GOhm even after 50 Mrad(Si) dose, thus proving the p-spray robustness. We present the most important design and technological aspects, and results obtained from the initial investigations.

Development of Single- and Double-sided Ladders for the ILD Vertex Detectors

Development of CMOS Pixel Sensors fully adapted to the ILD Vertex Detector Requirements

Development of Fast and High Precision CMOS Pixel Sensors for an ILC Vertex Detector

Developing a Monolithic Silicon Sensor in a 65 nm CMOS Imaging Technology for Future Lepton Collider Vertex Detectors

Vertex-Detector R&D for CLIC

First Results with Prototype ISIS Devices for ILC Vertex Detector

A Full Functional Monolithic Active Pixel Sensor Prototype for the CEPC Vertex Detector

Digital Pixel Test Structures implemented in a 65 nm CMOS process

Development of novel low-mass module concepts based on MALTA monolithic pixel sensors

Development of depleted monolithic pixel sensors in 150 nm CMOS technology for the ATLAS Inner Tracker upgrade

Characterization of passive CMOS sensors with RD53A pixel modules

R&D for the CLIC Vertex and Tracking detectors

Electrical Characterization of a Thin Edgeless N-on-p Planar Pixel Sensors For ATLAS Upgrades

Hybrid pixel detector development for the linear collider vertex detector

SLID-ICV Vertical Integration Technology for the ATLAS Pixel Upgrades

Development of n-in-p pixel modules for the ATLAS Upgrade at HL-LHC

M.i.p. detection performances of a 100 us read-out CMOS pixel sensor with digitised outputs

Novel Silicon n-on-p Edgeless Planar Pixel Sensors for the ATLAS upgrade

First Production of New Thin 3D Sensors for HL-LHC at FBK

200 mm sensor development using bonded wafers

DEPFET Vertex Detectors: Status and Plans