Polymer-supported ultra-thin ZIF-67 membrane through in situ interface self-repair

Caijiao Yu,Yueyao Liang,Wenjuan Xue,Zhengqing Zhang,Xuemeng Jia,Hongliang Huang,Zhihua Qiao,Donghai Mei,Chongli Zhong

DOI: https://doi.org/10.1016/j.memsci.2021.119139

IF: 9.5

2021-05-01

Journal of Membrane Science

Abstract:<p>Metal-organic framework (MOF) membranes have significant potential for use in efficient gas separation. However, fabricating polymer substrate-supported ultra-thin MOF membranes with no defects remains a challenge. Herein, we proposed an in situ interface self-repair strategy for fabricating ultra-thin and defect-free ZIF-67 membranes for the first time. This was realized by preparing a polyvinyl alcohol (PVA)-Co²⁺ interfacial layer containing a Co²⁺ ion layer and a PVA-Co²⁺ complex layer. The PVA-Co²⁺ interfacial layer released Co²⁺ ions and acted as a metal source to form ZIF-67 membranes by reducing the coordination rate of Co²⁺ ions with 2-methylimidazole. The embedded Co²⁺ ions functioned as anchor sites for the nucleation of ZIF-67 membrane assisted by the interface-enhanced deprotonation of 2-methylimidazole. Especially, the slow release of Co²⁺ ions from the PVA-Co²⁺ interfacial layer facilitated self-repair of defects to form a continuous and dense MOF layer. ZIF-67 membranes, 80-280 nm thick, were successfully synthesized and demonstrated unprecedented CO₂ permeance and good CO₂/N₂ selectivity. This work provides a promising strategy for the fabrication of ultra-thin and defect-free MOF membranes on polymeric support layers for use in practical applications.</p>

engineering, chemical,polymer science

What problem does this paper attempt to address?

The problem that this paper attempts to solve is to prepare defect - free ultrathin metal - organic framework (MOF) membranes, especially ZIF - 67 membranes, for efficient gas separation. Traditional MOF membrane preparation methods are difficult to avoid defects in the membranes, which limits their performance in practical applications. This paper proposes an in - situ interface self - repair strategy. By forming a PVA - Co²⁺ interface layer containing a Co²⁺ ion layer and a PVA - Co²⁺ composite layer on a polymer substrate, a continuous and dense ultrathin ZIF - 67 membrane is prepared. This method not only improves the heterogeneous nucleation probability of MOF at the interface, but also promotes the in - situ repair of membrane defects, thus successfully synthesizing ultrathin ZIF - 67 membranes with a thickness of 80 - 280 nanometers in water for the first time. These membranes exhibit excellent CO₂ permeability and good CO₂/N₂ selectivity, providing a promising strategy for practical applications.