Abstract:The particles transported by slurry pumps in practical engineering are non-spherical, but the current research mainly focuses on spherical particles, which limits their further development. To investigate the non-spherical particle movement in the pump, the multi-sphere model is applied to construct a cylindrical particle model. The RANS-DEM approach is employed to analyze the movement characteristics of cylindrical particle within a slurry pump, and the effects of densities, concentrations, and shapes are considered. The research results indicate that the average velocity of cylindrical particle decreases with the increase in particle density. With the increase in density, the maximum average velocity of particles decreases about 7.3%, and the time to reach the peak decreases, about 15.6%. Additionally, cylindrical particles tend to move toward the pressure side in the impeller, while the accumulation of particles in the middle of the guide vane becomes more prominent. Moreover, the proportion of collisions between particles and guide vanes to total collision is reduced, about 5.9%. As the cylindrical particle concentration increases, the particle average velocity in the pump decreases and some particles deviate from the blade pressure side. The maximum velocity of particles with the lowest concentration is higher than that of the particles with the highest concentration, approximately 5.48%. The accumulation in the middle of the guide vane flow channel deteriorates and the total particle collisions increase. Compared with spherical particles, the average velocity of cylindrical particles is faster, about 1.01%. Cylindrical particles move more smoothly along the pressure side in the impeller. At the same time, the total collision numbers of cylindrical particles are 13.46% higher than that of spherical particles, and the collision type is mainly between particles and guide vanes. The effect of the particle properties parameters on pump performance could provide theoretical support for the design of high-performance deep-sea mining slurry pumps.

Characterization of the ellipsoidal particle motion in a two-stage lifting pump using CFD-DEM method

Research of Particle Motion in a Two-Stage Slurry Transport Pump for Deep-Ocean Mining by the CFD-DEM Method

Experimental Investigation on Drawdown of Floating Particles in Viscous Systems Driven by Coaxial Mixers

CFD-DEM analysis of internal flow characteristics in multistage deep-sea mining pumps

Particle Anti-Accumulation Design at Impeller Suction of Deep-Sea Mining Pump and Evaluation by CFD-DEM Simulation

Studying particle transport characteristics in centrifugal pumps under external vibration using CFD-DEM simulation

Impact of Particle Sizes on Flow Characteristics of Slurry Pump for Deep-Sea Mining

The effect of particle size on the reflux performance of the lifting pumps

Effect of Particle Factors on the Reflux and Blockage of a Deep‐Sea Six‐Stage Pump Based on CFD‐DEM (Adv. Theory Simul. 3/2024)

Design and Analysis of an Innovative Deep-Sea Lifting Motor Pump

Numerical study on cylindrical particle solid–liquid two-phase flow in a slurry pump

Balance of Efficiency and Security-influence on Slurry Transport from the Diffusion of Flow Passages of a Deep-sea Mining Pump

Study on Wear Characteristics of a Guide Vane Centrifugal Pump Based on CFD–DEM

Cavitation Performance Improvement of High Specific Speed Mixed-Flow Pump

Investigation on wear induced by solid-liquid two-phase flow in a centrifugal pump based on EDEM-Fluent coupling method

Experimental Study on the Mixing and Dispersing of Floating Particles in Viscous System

Optimizing Energy Efficiency in Deep-Sea Mining: A Study on Swirling Flow Transportation of Double-Size Mineral Particles

CFD-DEM investigation of centrifugal slurry pump with polydisperse particle feeds

Numerical Simulation of Hydrodynamics in Downers Using a CFD–DEM Coupled Approach

Numerical Simulation and Analysis on Hydraulic Performance in Vertical Canned Motor Pump

Influence on the Solid—Liquid Two-Phase Flow from Cross-Section Area of Slurry Pumps for Deep-Sea Mining