Fast Organic Vapor Phase Deposition of Thin Films in Light-Emitting Diodes

Boning Qu,Kan Ding,Kai Sun,Shaocong Hou,Steven Morris,Max Shtein,Stephen R. Forrest
DOI: https://doi.org/10.1021/acsnano.0c07017
IF: 17.1
2020-10-05
ACS Nano
Abstract:Fast deposition of thin films is essential for achieving low-cost, high-throughput phosphorescent organic light-emitting diode (PHOLED) production. In this work, we demonstrate rapid and uniform growth of semiconductor thin films by organic vapor phase deposition (OVPD). A green PHOLED comprising an emission layer (EML) grown at 50 Å/s with bis[2-(2-pyridinyl-<i>N</i>)phenyl-<i>C</i>](acetylacetonato)iridium(III) (Ir(ppy)<sub>2</sub>(acac)) doped into 4,4′-bis(<i>N</i>-carbazolyl)-1,1′-biphenyl (CBP) exhibits a maximum external quantum efficiency of 20 ± 1%. The morphology, charge transport properties, and radiative efficiency under optical and electrical excitation of the PHOLED EML are investigated as functions of the deposition rate <i>via</i> both experimental and theoretical approaches. The EML shows no evidence for gas phase nucleation of the organic molecules at deposition rates as high as 50 Å/s. However, the roll-off in quantum efficiency at high current progressively increases with deposition rate due to enhanced triplet-polaron annihilation. The roll-off results from accumulation of stress within the PHOLED EML that generates a high density of defect states. The defects, in turn, act as recombination sites for triplets and hole polarons, leading to enhanced triplet-polaron annihilation at high current. We introduce a void nucleation model to describe the film morphology evolution that is observed using electron microscopy.This article has not yet been cited by other publications.
materials science, multidisciplinary,chemistry, physical,nanoscience & nanotechnology
What problem does this paper attempt to address?