Abstract:This paper instructs the working principle of the well washing device and its parameter optimization in practical applications. A fluent fluid engineering simulation software was used to establish the calculation model of the bottom flow field. The fluid area inside the well washing device with different orifice diameters at 30, 40, 50, and 60 degrees was simulated, and the gas‐solid two‐phase distribution cloud map and corresponding data were obtained. The results show that the cleaning effect is optimal and with no dead angle when θ = 30° and d = 4 mm. Moreover, the optimization design using simulation technology is reliable and simple. Based on this conclusion, a patent for a cyclone reverse circulation well washing device was invented. Under the same conditions, the above results were also verified by comparison with ordinary washing devices. This paper instructs the working principle of the well washing device and its parameter optimization in practical applications. A fluent fluid engineering simulation software was used to establish the calculation model of the bottom flow field. The cyclone reverse circulation well washing device is designed on the basis of artificial tornado technology. When combined with the double wall drill pipe, the cyclone reverse circulation well washing device exhibits good performance in the salvage operation. The working principle is that the air enters the reduced diameter passage from the annular space between the inner and outer tubes of the double wall drill pipe and forms a high‐speed jet through the reduced diameter passage. A part of the high‐speed airflow flows through the outer orifice hole into the annulus between the well wall and the salvage, and the debris at the bottom of the hole bottom will be gathered to the center of the bottom of the hole. Another part of the high‐speed airflow is jetted through the inner swirling orifice to the passage in the device, where it forms a rising vortex flow. The accumulated debris in this circumstance will be drawn into the chip evacuation passage and returned to the ground through the inner pipe of the double‐walled drill.

A vacuum defoaming machine for slurry

Progress on agitated apparatus for polymer devolatilization and its CFD simulation

Hydrodynamics and Film Formation Characteristics in a Horizontal Self‐cleaning Twin‐shaft Kneader for Polymer Devolatilization

Design and Simulation Study of a Vacuum-pumping Deaerating Device for Hydraulic Oil

Analysis of Flow Field Characteristics in a Mechanical Defoaming Device

Numerical investigation on the intensification of coaxial slurry mixing systems

Application of Flocculation Combined with Vacuum Preloading to Reduce River-Dredged Sludge

The Design of A Degassing Pump Based on Numerical and Experimental Research

Vacuum Preloading Combined with Multiple-Flocculant Treatment for Dredged Fill Improvement

Development on Test Equipment of Coal Slurry Mixing Tank

Improving Consolidation of Dredged Slurry by Vacuum Preloading Using Prefabricated Vertical Drains (pvds) with Varying Filter Pore Sizes

Numerical Study on Clogging of Prefabricated Vertical Drain in Slurry under Vacuum Loading

Fluid simulation in a cyclone reverse circulation well washing device based on computational fluid dynamics

Dewatering characteristics of waste slurry from pipe jacking based on improved vacuum filtration method

Operation Experience of Sludge Centrifugal Dewatering Machine

Coupling Heat Pump and Vacuum Drying Technology for Urban Sludge Processing

Static and high -efficient dust removal defogging integrated device of inertia coupling

Defoamer for oil-gas separation

Vibration Damping and Noise Reduction of a New Non-Newtonian Fluid Damper in a Washing Machine

Dewatering and strength characteristics of dredged slurry under curing-flocculation-vacuum filtration

Effects of residual foaming agent and defoamer on defoaming-flocculation-filterpress characteristics of earth pressure balance shield muck