Abstract:As the volume of oil extraction continues to rise, the issue of oilfield wastewater treatment has become increasingly urgent. Traditional water treatment technologies struggle to effectively and economically eliminate the pollution caused by oilfield wastewater, as well as efficiently utilize its various components. This study proposes the utilization of oilfield wastewater for the preparation of coal water slurry, and the combustion experiments of coal oilfield wastewater slurry (COWS) and original coal water slurry (CWS) under various working conditions are conducted on a pilot-scale horizontal furnace. The investigation focused on the combustion characteristics, slagging characteristics and flue gas composition, as these indicators directly impact the industrial application of such slurry fuel. The combustion characteristics results reveal that both COWS and CWS demonstrate stable ignition and combustion across all working conditions, with combustion efficiency exceeding 99.69%, and the incorporation of oilfield wastewater promotes volatiles precipitation and combustion. The slagging characteristics results indicate that the flame temperature within the furnace is critical in determining slagging occurrence, and the incorporation of oilfield wastewater increases the likelihood of slagging. The flue gas composition measurement results indicate that the incorporation of oilfield wastewater slightly elevates carbon monoxide (CO) levels, albeit within a low concentration range. Additionally, oilfield wastewater demonstrates a modest reduction in sulfur dioxide (SO2) and nitrogen oxide (NOx) emissions. These test results underscore that incorporating oilfield wastewater into the preparation of fuel coal water slurry not only facilitates thorough treatment of oilfield wastewater, but also enhance the combustion performance of slurry fuel within the furnace, thereby offering significant industrial application potential.

Development on Test Equipment of Coal Slurry Mixing Tank

Influence of Slurry Velocity and Concentration Distributions on Fischer-Tropsch Synthesis in Slurry Bubble Column Reactor

Numerical Simulation of Mixing Capability in Coal-Slurry Mixing Tank

An Investigation on Characteristics of Coal–water Slurry Prepared from the Solid Residue of Plasma Pyrolysis of Coal

Numerical investigation on the intensification of coaxial slurry mixing systems

Study on Dispersion and Mixing Mechanism of Coal Slime Particles in Jet Mixing Flow Field

Slurry Ability of Coal Water Slurry Prepared with Two Kinds of Sewage Sludge

Study on basic features of sludge coal water slurry

Optimization of key link parameters and mechanism of the jet-stirring synergistic column flotation method

Pilot-Scale Investigation on Slurrying, Combustion, and Slagging Characteristics of Coal Slurry Fuel Prepared Using Industrial Wasteliquid

Experimental Study of Black-liquor Coal Slurry Combustion

Preparation Principle and Research Progress of Coal Pitch Water Slurry

Research on Characteristics of Coal Slurry in Wangfenggang Coal Preparation Plant

Ultrasonic Sludge Disintegration for Improving the Co-Slurrying Properties of Municipal Waste Sludge and Coal

Study on preparation of high mass fraction coal-water slurry from Huating coal

Rheological behavior in Xinglongzhuang coal washery sludge pump system of CFB boiler

Fluid–Solid Mixing Transfer Mechanism and Flow Patterns of the Double-Layered Impeller Stirring Tank by the CFD-DEM Method

Kinetic modeling and experimental verification of a swirl flocculation-enhanced reactor: A case study of coal chemical wastewater pretreatment

Field Test and Numerical Simulation for Co-combustion of Sludge in a 100,MW Coal Fired Boiler

Pilot-scale Study on Combustion Characteristics, Slagging Characteristics and Flue Gas Composition of Coal Oilfield Wastewater Slurry

Co-Combustion Characteristics of Municipal Sewage Sludge and Coal in a Lab-Scale Fluidized Bed Furnace