Abstract:Low-cost mesoporous silicas of the SBA-15 family were prepared, aimed for removal of a broad spectrum of both cationic and anionic forms of hazardous metal pollutants (Cr(III, VI), Mn(II, VII), Pb(II), Cd(II), and Cu(II)) from environmental water. Series of mono- and bifunctional materials with immobilized ethylenediaminetriacetic acid (EDTA), primary amine (NH), and quaternary ammonium (QAS) groups were prepared in a cost-efficient one-step synthesis using two silica sources, low-cost sodium metasilicate (NaSiO 9HO) and the conventional source-tetraethylorthosilicate (TEOS). The functionalized SBA-15 samples obtained from both silica sources were highly ordered, as evidenced by TEM and SAXS data. All obtained materials were mesoporous with high surface area values of up to 745 m/g, pore volumes from 0.99 to 1.44 cm/g, and narrow pore distributions near 7 nm. The adsorption affinity of the EDTA-functionalized samples followed the common order Pb(II)> Cd(II)> Cu(II)> Cr(III)> Mn(II), which could be explained based on the Pearson theory. The highest adsorption capacities were observed for samples functionalized by EDTA groups using TEOS for synthesis (TEOS/EDTA): 195.6 mg/g for Pb(II), 111.2 mg/g for Cd(II), 58.7 mg/g for Cu(II), 57.7 mg/g for Cr(III), and 49.4 mg/g for Mn(II). Moreover, organic matter (humic acid up to 10 mg/L) and inorganic (Na(I), K(I), Mg(II), Ca(II), etc) macrocomponents present in environmental water had almost negligible effect on the removal of these cations. The NaSi/EDTA/NH sample revealed a better selectivity compared to the NaSiNH sample towards such species as Cr(III), Mn(II), Cd(II), and Cu(II). The chromate-ions uptake at pH 7.5 by the TEOS/QAS sample turned practically unaffected by the presence of doubly charged anions (CO , SO ). The content of functional groups on the surface of MS decreased only slightly (∼1-5%) after several regeneration cycles. The complete desorption of all heavy metal ions can be achieved using 1 mol/L EDTA solution. Reusability tests demonstrated the complete stability of the adsorbent for at least five to six consecutive adsorption/desorption cycles with no decrease in its adsorption characteristics compared to those obtained by 0.05 mol/L HNO treatments. The synthesized mesoporous materials were evaluated for removal of the heavy metal ions from drinking and different natural water samples, proving their potential as sustainable, effective, and cost-efficient adsorbents.

Defective SO 3 H-MIL-101(Cr) for capturing different cationic metal ions: Performances and mechanisms

Defective SO3H-MIL-101(Cr) for Capturing Different Cationic Metal Ions: Performances and Mechanisms.

The Efficient Removal of Low Concentration Hexavalent Chromium Via Combining Charged Microporous Membrane and Micellar Adsorption Filtration

Surface defects enhance the adsorption affinity and selectivity of Mg(OH)2 towards As(v) and Cr(vi) oxyanions: a combined theoretical and experimental study

Multi-ligand strategy for enhanced removal of heavy metal ions by thiol-functionalized defective Zr-MOFs

Nanomagnetic Polyhedral Oligomeric Silsesquioxanes Composite Derived Sulfur-Containing Adsorbents for Effective Elimination of Hexavalent Chromium and Organic Cationic Dyes from Water

Fabrication of highly efficient magnesium silicate and its adsorption behavior towards Cr(VI)

Amine-functionalized cellulose nanofiber-sodium alginate-Fe(III) porous hollow beads for the efficient removal of Cr(VI)

Network–Polymer–Modified Superparamagnetic Magnetic Silica Nanoparticles for the Adsorption and Regeneration of Heavy Metal Ions

Ultra-purification of heavy metals and robustness of calcium silicate hydrate (C–S–H) nanocomposites

Efficiently removal of ciprofloxacin from aqueous solution by MIL-101(Cr)-HSO3: the enhanced electrostatic interaction

Magnetic iron-based waterworks sludge modified by chitosan and FeS for aqueous Cr(vi) adsorption and reduction

Efficient and selective Lead(II) removal within a wide concentration range through chemisorption and electrosorption coupling process via defective MoS2 electrode

The Defects, Physicochemical Properties, and Surface Charge of MIL-88A (Al) Crystal Were Regulated for Highly Efficient Removal of Anionic Dyes: Preparation, Characterization, and Adsorption Mechanism

Adsorptive Removal of Pb(II) Ions from Aqueous Samples with Amino-Functionalization of Metal-Organic Frameworks MIL-101(Cr)

Disclosing the role of defective UiO-66 over Sb(V) removal: A joint experimental and theoretical study

Bi-functionalized MCM-41 for heavy metal ions removal: synthesis, enhanced performance and mechanism study

Effective removal of Cr(VI) from aqueous solution through adsorption and reduction by magnetic S-doped Fe-Cu-La trimetallic oxides

Magnetic Poly(aniline-Co-5-sulfo-2-anisidine) As Multifunctional Adsorbent for Highly Effective Co-Removal of Aqueous Cr(VI) and 2,4-Dichlophenol

Investigating the adsorption behavior and mechanisms of insoluble Humic acid/starch composite microspheres for metal ions from water

In situ Functionalized Mesoporous Silicas for Sustainable Remediation Strategies in Removal of Inorganic Pollutants from Contaminated Environmental Water.