Abstract:The use of superhydrophobic surfaces in a broad range of applications is receiving a great deal of attention due to their numerous functionalities. However, fabricating these surfaces using low-cost raw materials through green and fluorine-free routes has been a bottleneck in their industrial deployment. This work presents a facile and environmentally friendly strategy to prepare mechanically robust superhydrophobic surfaces with engineered lotus leaf mimetic multiscale hierarchical structures via a hybrid route combining soft imprinting and spin-coating. Direct soft-imprinting lithography onto starch/polyhydroxyurethane/cellulose nanocrystal (SPC) films formed micro-scaled features resembling the pillar architecture of lotus leaf. Spin-coating was then used to assemble a thin layer of low-surface-energy poly(dimethylsiloxane) (PDMS) over these microstructures. Silica nanoparticles (SNPs) were grafted with vinyltriethoxysilane (VTES) to form functional silica nanoparticles (V-SNPs) and subsequently used for the fabrication of superhydrophobic coatings. A further modification of PDMS@SPC film with V-SNPs enabled the interlocking of V-SNPs microparticles within the cross-linked PDMS network. The simultaneous introduction of hierarchical microscale surface topography, the low surface tension of the PDMS layer, and the nanoscale roughness induced by V-SNPs contributed to the fabrication of a superhydrophobic interface with a water contact angle (WCA) of ∼150° and a sliding angle (SA) of <10°. The PDMS/V-SNP@SPC films showed an ∼52% reduction in water vapor transmission rate compared to that of uncoated films. These results indicated that the coating served as an excellent moisture barrier and imparted good hydrophobicity to the film substrate. The coated film surfaces were able to withstand extensive knife scratches, finger-rubbing, jet-water impact, a sandpaper-abrasion test for 20 cycles, and a tape-peeling test for ∼10 repetitions without losing superhydrophobicity, suggesting superior mechanical durability. Self-cleaning behavior was also demonstrated when the surfaces were cleared of artificial dust and various food liquids. The green and innovative approach presented in the current study can potentially serve as an attractive new tool for the development of robust superhydrophobic surfaces without adverse environmental consequences.

Fabrication of hydrophobic inorganic coatings on natural lotus leaves for nanoimprint stamps

Superhydrophobic poly(vinylidene fluoride) film fabricated by alkali treatment enhancing chemical bath deposition

Fabricating Super‐Hydrophobic Lotus‐Leaf‐Like Surfaces Through Soft‐Lithographic Imprinting

Superhydrophobicity of polyvinylidene fluoride membrane fabricated by chemical vapor deposition from solution

Fabrication of Self-Cleaning Polyvinylidene Fluoride Film

Super-hydrophobic and Self-cleaning PVDF Film Fabricated by Chemical Bath Deposition

Biomimetic high water adhesion superhydrophobic surface via UV nanoimprint lithography

Fabrication Method of Binary Micro-structure Super-hydrophobic Surface Based on Lotus Effect

Regenerative Superhydrophobic Coating from Microcapsules

Superhydrophobic lotus-leaf-like surface made from reduced graphene oxide through soft-lithographic duplication

Facile Fabrication of Superhydrophobic Nanocomposite Coatings Based on Water‐Based Emulsion Latex

Fabrication of lotus-leaf-like superhydrophobic surfaces via Ni-based nano-composite electro-brush plating

ZnO Micro–nano Composite Hydrophobic Film Prepared by the Three-Step Method

Preparation of a Cu Surface with the Hierarchical Structure of a Lotus Leaf Via Electroplating and Its Superhydrophobicity

Robust and Eco-Friendly Superhydrophobic Starch Nanohybrid Materials with Engineered Lotus Leaf Mimetic Multiscale Hierarchical Structures

Lotus Leaf Inspired Robust Superhydrophobic Coating from Strawberry-Like Janus Particles

Biomimetic fabrication and tunable wetting properties of three-dimensional hierarchical ZnO structures by combining soft lithography templated with lotus leaf and hydrothermal treatments

Papillae Mimetic Hairy Composite Spheres Towards Lotus Leaf Effect Coatings

Superhydrophobic Waxy-Dendron-Grafted Polymer Films Via Nanostructure Manipulation

Lotus Leaf-Like Dual-Scale Silver Film Applied As A Superhydrophobic and Self-Cleaning Substrate

Hybrid Topography of Lotus Leaf under Hydrostatic/Hydrodynamic Pressure