Electrostatic Control of the Evolution from Superconductor to Insulator in Ultrathin Films of Yttrium Barium Copper Oxide

Xiang Leng,Javier Garcia-Barriocanal,Yeonbae Lee,Allen M. Goldman

DOI: https://doi.org/10.48550/arXiv.1104.1357

2011-04-07

Abstract:The electrical transport properties of ultrathin YBCO films have been modified using an electric double layer transistor configuration employing an ionic liquid. The films were grown on SrTiO3 substrates using high pressure oxygen sputtering. A clear evolution from superconductor to insulator was observed in nominally 7 unit cell thick films. Using a finite size scaling analysis, curves of resistance versus temperature, R(T), over the temperature range from 6K to 22K were found to collapse onto a single scaling function, which suggests the the presence of a quantum critical point. However the scaling failed at the lowest temperatures suggesting the presence of an additional phase between the superconducting and insulating regimes.

Superconductivity,Materials Science,Strongly Correlated Electrons

What problem does this paper attempt to address?

The problem that this paper attempts to solve is to use ionic liquids to regulate the electrical transport properties of yttrium barium copper oxide (YBCO) ultrathin films through the electric double - layer transistor (EDLT) configuration, in order to achieve the transition from the superconducting state to the insulating state. Specifically, the researchers hope to verify the following points:

1. **Superconducting - insulating phase transition**: By changing the gate voltage to adjust the carrier concentration, a transition from the superconducting state to the insulating state is induced in the ultrathin YBCO film. This process involves a quantum phase transition (QPT), that is, a phase transition caused by changes in external parameters (such as thickness, magnetic field, and carrier concentration) at zero temperature.

2. **Existence of the quantum critical point**: Using the finite - size scaling analysis method, verify whether there is a quantum critical point (QCP). According to theoretical predictions, when approaching the quantum critical point, the resistance data of the system should be able to collapse onto a single scaling function, that is:
\[
R = R_c f\left(\frac{\delta}{T^{\nu z}}\right)
\]
where \(R_c\) is the critical resistance, \(\delta\) is the tuning parameter, \(T\) is the temperature, \(\nu\) is the correlation length critical exponent, and \(z\) is the dynamic critical exponent.

3. **Exploration of new physical phenomena**: At the lowest temperature, the experimental results show non - monotonic behavior similar to that of granular superconductors, indicating that there may be a mixed phase between the superconducting and insulating states. This suggests that new physical mechanisms are at work at low temperatures, so that the superconducting - insulating transition does not occur directly.

Through these studies, the author hopes to gain a deeper understanding of the quantum phase transition mechanism in high - temperature superconductors and provide theoretical and technical support for future device applications.