Abstract:Two promising high-entropy alloys (HEAs) AlxCrFe1.5MnNi0.5 (x = 0.3 and 0.5) were designed from Al–Co–Cr–Cu–Fe–Ni alloys by substituting Mn for expensive Co and excluding Cu to avoid Cu segregation. Microstructures and properties were investigated and compared at different states: as-cast, as-homogenized, as-rolled and as-aged states. Al0.3CrFe1.5MnNi0.5 alloy in the as-cast, as-homogenized and as-rolled states has a dual-phase structure of BCC phase and FCC phase, in which Al, Ni-rich precipitates of B2-type BCC structure disperse in the BCC phase. Al0.5CrFe1.5MnNi0.5 alloy in the corresponding states has a matrix of BCC phase in which Cr-rich particles of BCC structure and Al, Ni-rich precipitates of B2-type BCC structure disperse. These three BCC phases have the same lattice constant. Both alloys are workable and show a hardness range of Hv 300–500 in the as-cast, as-forged, as-homogenized and as-rolled states. Al0.5CrFe1.5MnNi0.5 alloy has a higher hardness level than Al0.3CrFe1.5MnNi0.5 one because of its full BCC phase. Both alloys thus can be used as structural parts requiring stronger strength. Both alloys display a significant high-temperature age-hardening phenomenon. As-cast Al0.3CrFe1.5MnNi0.5 alloy can attain the highest hardness, Hv 850, at 600 °C for 100 h, and Al0.5CrFe1.5MnNi0.5 can get even higher hardness, Hv 890. The aging hardening is resulted from the formation of ρ phase (Cr5Fe6Mn8-like phase). Prior rolling on the alloys before aging could significantly enhance the age-hardening rate and hardness level due to introduced defects. Al0.5CrFe1.5MnNi0.5 alloy exhibits excellent oxidation resistance up to 800 °C, which is better than Al0.5CrFe1.5MnNi0.5 alloy. Combining this merit with its high softening resistance and wear resistance as compared to commercial alloys Al0.5CrFe1.5MnNi0.5 alloy has the potential for high-temperature structural applications.

Study on the Effect of Aging Treatment on the Microstructure and Properties of Fe24Co27Ni32Cr8Al6Ti3 High-Entropy Alloy

Enhancing the Strength of AlCrFeNi HEAs Via Tailoring Aluminum Content and Optimal Aging Treatment

Study on Precipitation in (cocrfemnni)90al6ti4 High Entropy Alloy

Effect of aging temperature on microstructure and mechanical properties of Fe–Ni–Cr–Al high entropy alloy

Aging temperature effect on the phase composition, microstructure, and selected mechanical properties of non-equiatomic TiZrNbTaMo/Mn HEAs targeted for biomedical implants

Microstructure and corrosion resistance properties of (FeCoNi)86Al7Ti7 high-entropy alloy via different aging time

Microstructure and Aging Behaviour of Al5cr32fe35ni22ti6 High Entropy Alloy

Microstructural evolution, mechanical and corrosion behavior of an Al7.5Co20.5Fe24Ni24Cr24 high‐entropy alloy

Microstructure-Property Correlation and Its Evolution during Aging in an Al4.4Co26Cr19Fe18Ni27Ti5.6 High-Entropy Alloy

Effect of Solution and Aging Treatments on the Microstructure and Mechanical Properties of Dual-Phase High-Entropy Alloy Prepared by Laser-Powder Bed Fusion using AlSi10Mg and FeCoCrNi Powders

Microstructure Evolution and Tensile Properties Behavior During Aging Temperature of Cocrfeni-Based High Entropy Alloys

Effect of Heat Treatment on the Microstructure and Mechanical Properties of the Al0.6CoCrFeNi High-Entropy Alloy

Effect of heat treatment on hydrogen embrittlement susceptibility of Al 0.25 CoCrFeNi high entropy alloy

Microstructure and Properties of Age-Hardenable AlxCrFe1.5MnNi0.5 Alloys

Effect of Aging Treatment on Microstructural Evolution and Mechanical Properties of the Electron Beam Cold Hearth Melting Ti-6Al-4V Alloy

Effect of Cold Deformation and Heat Treatment on the Microstructure and Mechanical Behavior of High Entropy Alloy CuCrFeNi2Al0.5

Precipitation behaviors of the rapidly-solidified CoCrFeNiTi high-entropy alloy during aging treatment

Effect of different durations on the microstructure and tribological behavior of (Co1.5FeNi)90Ti6Al4 high entropy alloy

Microstructure, Mechanical Property, and Wear Behavior of NiAl-Based High-Entropy Alloy

Effect of heat treatment on microstructure and mechanical property of Ti-6Al-2.5V-1.5Fe-0.15O alloy

Role of Aging Temperature on Thermal Stability of Co-free Cr0.8FeMn1.3Ni1.3 High-Entropy Alloy: Decomposition and Embrittlement at Intermediate Temperatures