Abstract:Utilization of low-grade heat has attracted considerable attention as an inspiring pathway towards sustainable and low-carbon energy future. However. low-grade heat, either in the form of natural source or waste heat, is abundantly available but not yet effectively exploited. With the outstanding merits of free maintenance and high reliability, thermoacoustic engine is conceived as one of cost-effective and reliable alternative technologies for low-grade heat recovery. Most recently, two-phase thermoacoustic engine induced increasing interest, thanks to its capability of running across a small temperature difference between heat source and heat sink. In this work. a vapor-liquid phase-change thermoacoustic engine, where the working fluid undergoes periodic condensation and evaporation, is constructed to realize low temperature-differential operation. The engine consists of a looped thermoacoustic unit and a branch resonator, where the former contains a cold heat exchanger. a regenerator. a hot heat exchanger and segments of tubes, while the latter contains a gas reservoir and a load tube. R134a is adopted as the working fluid in the preliminary study of this thermoacoustic engine, for its boling point near ambient temperature at the operating pressure around 0.5 MPa. Besides, R1234ze(E) is also used as the working fluid. thanks to its zero ozone depletion potential and low global warming potential. The experiments focus on onset temperature and pressure ratio, since the former determines the lowest grade of usable heat source, while the latter is an essential parameter for evaluating the intensity of pressure oscillation. The results show that an onset temperature of 18.1 degrees C. lowest ever reported, can be achieved with R134a as working fluid when the regenerator is packed with copper mesh screens. The highest pressure ratio of 1.094 is achieved with R1234ze(E) as working fluid at a hot temperature of 183 degrees C and a heating power of 200 W. which is comparable to the single-stage looped travelling wave thermoacoustic engine with helium of 1 MPa as working fluid at a similar hot temperature but a much lower heating power. Besides, the onset temperature firstly drops and then rises with the decreasing mesh number of regenerator's mesh screen, while the pressure ratio always rises. It is also found that regenerator material has marked effect on the engine performance. The engine with copper mesh screen achieves the lowest onset temperature, then stainless steel, and finally nylon. Besides, the cases of pressure ratio are in the increasing order of nylon_ stainless steel and copper. The low temperature-differential onset enables the phase-change thermoacoustic engine to harvest the near roomtemperature heat source. Further work on performance optimization of this novel thermoacoustic engine is still necessary and will be our near future work.

Jet-type automobile air conditioner

Research on Two-stage Jet Refrigerant System with Water as Working Medium for Recycling Automotive Waste Heat

A Vapor-Liquid Phase-Change Thermoacoustic Engine Driven by Near Room-Temperature Heat Source

Thermal management system for motor train traction converter

Window-type air conditioner with fresh air exchange function

Portable air conditioner and air purifier all-in-one machine

Dual Functional Heat Pump Type Solar Industrial Boiler Thermodynamic System and Method Thereof

Chilled water type machine room air conditioner of fluorine pump double-circulation natural cold source cold storage system

Air conditioner with air purifier and control method thereof

Thermal management system used for electric locomotive traction converter

Heat management system for electric locomotive traction converter

Carbon dioxide heat pump water heating system and carbon dioxide heat pump water heating device with same

Centrifugal compressor with asymmetrical vaneless diffuser and automobile with same

Dual-fluid microbubble jet generation device

Equipment compartment temperature and pressure control system and regulation and control method

Cooling system for converter

Simulation of Adsorption Air-Conditioner Used in Internal-Combustion Locomotive Driver-Cabin

The Application of Thermo-jet in Refrigeratory

Metal Hydride Refrigeration Cycle Driven by Automotive Exhaust Gas

Liquid gas rapid refrigerating device embedded into electrical refrigerating system and use method

Automotive Adsorption Air Conditioner Powered by Exhaust Heat. Part 1: Conceptual and Embodiment Design