Abstract:The Cu materials are playing an irreplaceable role in modern marine facilities, while one major issue affecting their service life is corrosion attack caused by external erosion of chloride ions, which leads to the quickly structural deterioration and reduced durability. To solve this obstinate issue, the corrosion−resistant Ni−based composite films with conductive Yttria–stabilized zirconia (YSZ, 2.5–15 g/L) and non−conductive Si 3 N 4 (2.5–15 g/L) reinforcing phases were composite–electrodeposited on Cu substrate in direct current (DC) mode. It was believed that the electrical differences of incorporated nanoparticles have a significant impact on nucleation and growth behaviors during electrodeposition, which further altered the structure and property of Ni−based composite films. Therefore, the emphasis of this study was to establish the correlation between obtained structure, electrochemical, and immersion corrosion performances at different incorporation levels of YSZ/Si 3 N 4 nanoparticles. The results demonstrate that by increasing the total doping contents, the Electrochemical Impedance Spectroscopy (EIS) and Chronoamperometry (CA) measurements exhibited an initial increase followed by a subsequent decrease on co−deposition dynamics, which was related to the dominant impact of conductive YSZ nanoparticle at electrocrystallization process. Meanwhile, the moderate incorporation level of 15 g/L offered effective control over structural compactness through dispersion−strengthening and grain−refining, and the same ratio of YSZ/Si 3 N 4 nanoparticles further maximized the improvement degree of microhardness, electrochemical passivation, and immersion stability of resulting films. Besides, the corrosion current density ( j corr ) of Ni−YSZ−Si 3 N 4 composite coating under optimum condition of 15 g/L was two orders of magnitude smaller than that of Cu substrate after long−term immersion test, and the corresponding polarization resistance ( R p ) also increased by 8.6 times. Overall, these substantial alterations obtained provide effective guideline for the design and preparation of corrosion−resistant Ni−based composite coating, which is beneficial to prolonging the service life of Cu components in saline environments.

Corrosion of Copper-Nickel Alloys in Seawater-Based Electrolytes

Long-Term Corrosion Behavior of Cu-10Ni and Cu-20Ni Alloys in Simulated Seawater

Corrosion Behavior of Ni/NiCr/NiCrAlSi Composite Coating on Copper for Application as a Heat Exchanger in Sea Water

Corrosion of Copper, Cupronickel, Nickel Aluminium Bronze and Super-Duplex Stainless Steel Rotating Cylinder Electrodes in Seawater under Turbulent Flow Conditions

Corrosion Evolution of Nickel Aluminum Bronze in Clean and Sulfide-Polluted Solutions

Corrosion Mechanisms of Plasma Welded Nickel Aluminium Bronze Immersed in Seawater

Electrodeposition fabrication of corrosion−resistant Ni–based composite film on surface of Cu: Role of conductive YSZ and non−conductive Si 3 N 4 nanoparticles

Insight to corrosion mechanism of 90/10 copper-nickel alloys under different sea depths

Electrochemical Corrosion Behavior of Cu-15Ni-8Sn Alloy in Marine Microbial Medium

Performance of a Ship-Based Cupronickel Alloy in Exposure Conditions of Arabian Seawater-A Comparative Study

Corrosion Behavior of Nanostructured Ni‐Si3N4 Composite Films: A Study of Electrochemical Impedance Spectroscopy

Electrochemical Corrosion Behavior of Nickel-Coated Carbon Fiber Materials in Various Electrolytic Media

The Effect of Chloride Ion on Corrosion Behavior of Ni-P Alloy Coating Using SECM Experiment and COMSOL Simulation

Mechanism of corrosion and sedimentation of nickel electrodes for alkaline water electrolysis

Corrosion behavior and electrochemical properties of carbon steel, commercial pure titanium, copper and copper–aluminum–nickel alloy in 3.5% sodium chloride containing sulfide ions

Insight into the corrosion susceptibility and failure mechanism of Cu-Ni alloy pipeline welded joints in simulated marine environment

Corrosion behavior of austenitic stainless steel and nickel-based welded joints in underwater wet welding

Corrosion Resistance, Composition, and Stratification of Passive Films: Ni-22Cr and Ni-22Cr-6Mo Alloys Passivated and Exposure Aged in Acidic Chloride Solutions

Galvanic Corrosion Behavior of Copper/titanium Galvanic Couple in Artificial Seawater

Galvanic corrosion of copper/titanium in aircraft structures using a cyclic wet/dry corrosion test in marine environment by EIS and SECM techniques

Influence of nano chromium addition on the corrosion and erosion–corrosion behavior of cupronickel 70/30 alloy in seawater