Thermo-mechanical behavior of a zinc die casting alloy considering natural aging
Maria,Los,Angeles,M. Page
DOI: https://doi.org/10.21268/20191217-1
2019-12-17
Abstract:Nowadays, a main task in the production sector is the optimization of components and
production processes in order to reduce costs and improve the quality of products. Nu-
merical simulations have become a fundamental tool, as they allow the optimization
even before the actual production starts. For the simulation of the mechanical behavior
of component parts, an appropriate constitutive material model is necessary. Since ma-
terial behavior is usually very complex, models are developed for a specific application
area.
The zinc die casting alloy Zamak 5 is widely used in the automotive industry because
of its excellent castability and its good mechanical properties. However, it exhibits a
complex thermo-mechanical behavior, which additionally changes gradually over the
course of time. This effect is known as aging and is caused by microstructural changes
such as diffusion, phase transformation and precipitation in the material. These pro-
cesses are temperature activated.
This thesis proposes a material model of thermo-viscoplasticitywith the goal of repro-
ducing the thermo-mechanical behavior of the alloy Zamak 5 considering the influence
of natural aging in finite element computations. This is performed on the basis of an
extensive experimental campaign, in which the thermo-mechanical behavior is charac-
terized with tension, compression and torsion tests at different loading conditions and
for different aging times. The material shows a strong rate and temperature dependence
and a moderate dependence on natural aging. Additionally, several thermo-physical
properties which are necessary in the heat equation are also measured. Moreover, the
microstructure of the alloy is investigated with a scanning electron microscope and X-
ray diffractometry for different aging times in order to describe the microstructural pro-
cesses which take place during aging.
At first, the material model is developed for the small deformation case since, in
this case, the torsion tests can be considered as one-dimensional and purely deviatoric,
which is advantageous during the identification process. Moreover, several temperature
and aging dependent material functions are developed during the identification process.
The model is extended later on to the finite strain case in order to be able to compute
processes in which the strains are larger than 5%. The models are based on the additive
decomposition of the strain tensor (for the small strain model) or multiplicative decom-
position of the deformation gradient (for the finite strain model). In both cases, there
is a component representing each of the different effects contained in the model: aging,
temperature and rate-dependence. Furthermore, the total stress is decomposed into an
equilibrium and an overstress part in order to identify them in a partitioned manner.
The model is implemented in the finite element code Abaqus. The behavior of the
model is demonstrated using several simulation examples. Finally, simulations of a real
component part (steering-wheel lock of a car), and a cylinder with a hole are compared
with complex experiments in which inhomogeneous stress and strain states are reached
for different loading conditions. With this information, the developed material model is
validated.
Engineering,Materials Science