Abstract:Abstract Purpose One of the key challenges in the research of phononic crystals is achieving small-size control of large wavelengths, which means obtaining low-frequency band gaps with relatively small lattice dimensions. Previous studies have mostly been unsatisfactory in this regard. To obtain lower starting frequencies and more satisfactory band gap widths, this work presents a novel design for a phononic crystal structure. Design Approach The proposed phononic crystal consists of a silicon rubber connecting plate, an epoxy resin substrate, and tungsten metal cone scatterers. Through finite element method (FEM) calculations and analysis, we have successfully achieved an ultrawide band gap. To delve further into the origin of the ultra-wideband gap in a newly conceived phononic crystal, the vibrational modes of this crystal were carefully studied. Findings This work has successfully achieved an ultrawide band gap with a width ranging from 122.47 to 4360.2 in the case of a lattice constant of a = 8.5 mm. It was found that the low-frequency ultra-wideband gap cannot be obtained without the presence of silicone rubber. Furthermore, an equivalent spring model was developed, and the accuracy of this model was successfully validated through meticulous calculations. At last, It is found that d1, d4, h1, and h3 have the most pronounced effect on the ultrawide bandgap, and the intrinsic reason is the fact that they determine the geometric structure of the silicone rubber connection plate. Research Limitations/implications Due to the chosen research method of finite element analysis, the study results may vary depending on the different mesh discretizations, but this type of error is small and can be ignored. Practical Implications This work provides a new design solution for phononic crystal miniaturization. Originality/value Compared with previous reports, the new phonon crystals designed in this paper have smaller size, lower starting frequency, and wider band gap.

Widening the frequency bandgap and reducing thermal conductivity in phononic crystals by tuning structural parameters using a novel computational simulation method

Multi-band Design for One-Dimensional Phononic Crystals

Thermal Tuning of the Interfacial Adhesive Layer on the Band Gaps in a One-Dimensional Phononic Crystal

Tuning the Thermal Conductivity of Silicon Phononic Crystals Via Defect Motifs: Implications for Thermoelectric Devices and Photovoltaics

Widening the bandgap of phonon crystal through its structure parameter optimization

Thermal tuning of band structures in a one-dimensional phononic crystal

Three-dimensional phononic crystals with self-similar structures

Bandgap Structures Of Sh-Wave In A One-Dimensional Phononic Crystal With Viscoelastic Interfaces

Thomson scattering-induced bandgap in planar chiral phononic crystals

Crystal structure dependent thermal conductivity in two-dimensional phononic crystal nanostructures

Numerical Modelling and Optimization of Two-Dimensional Phononic Band Gaps in Elastic Metamaterials with Square Inclusions

Super-Suppression of Long Phonon Mean-Free-Paths in Nano-engineered Si due to Heat Current Anticorrelations

Low-Frequency Ultrawide Band Gap Study of Symmetric Conical Scatterer Phononic Crystal

Design of Low-Frequency 1D Phononic Crystals Harnessing Compression–twist Coupling Effect with Large Deflection Angle

Reduction of Thermal Conductivity by Nanoscale 3D Phononic Crystal

3-D phononic crystals with ultra-wide band gaps

Monte Carlo simulations for phonon transport in silicon nanomaterials

Interference, scattering, and transmission of acoustic phonons in Si phononic crystals

On the lowest-frequency bandgap of 1D phononic crystals

Bandgap Calculation and Experimental Analysis of Piezoelectric Phononic Crystals Based on Partial Differential Equations

Study of Band Gaps of Two-Dimensional Phononic Crystals with Criss-Crossed Elliptical Holes