Influence of roller chopper parameters on the quality of corn cob chopping

V. Kuzmenko,

DOI: https://doi.org/10.37204/2786-7765-2023-3-11

2023-01-01

Abstract:Purpose. To determine experimentally the effect of the gap between the rollers, the difference in the speed of the rollers on the quality of corn grinding. Methods. Monographic, calculation and design methods were used during the research. The resulting raw wine was analyzed using sieve analysis. The quality of grinding was evaluated by the weighted average particle size – the grinding module and the percentage of particles in the crushed mass less than 40 mm in size. In processing and analyzing the results, statistical and regression analysis methods were used along with graphical methods. Results. According to the experimental results, the closeness of the relationship between the grinding module and the percentage of particles in the crushed mass less than 40 mm in size was determined. The dependence between the size of corn kernels and their weight was established. The dependences of the influence of the gap between the rollers and the difference in the speed of the rollers on the quality of corn grinding were determined. Conclusions 1. The developed experimental roller shredder allows us to study the influence of raw material parameters and design parameters in production conditions: circumferential speed and ratio of roll speeds, gap between rolls, roll compression force, height and pitch of reefs. 2. In the process of ripening, the humidity of the cob decreases from 45 % to 25 %, while the proportion of grain in the cob increases. The length of 80 % of corn kernels is 6–9 mm. The mass of the cob is 75–225 g, the average diameter varies between 34–43 mm and depends on the length of the cob, and these indicators are correlated with each other, the coefficient of determination is R = 0.784. 3. An increase in the compression force of the rollers in the range from 350 to 1750 N, the speed ratio from 1.0 to 2.5 contributes to the improvement of the grinding quality for all standard sizes of the rollers. At the same time, the grinding modulus decreases from 5.8 to 4.0 mm for the studied standard sizes of rollers in the first case and from 6.8 to 3.5 mm in the second case. The nature of the change in dependencies is linear for both cases. An increase in the gap between the rollers worsens the grinding quality. For a gap between the rollers of more than 4 mm, the share of raw materials smaller than 4 mm is only 19–28 %. The nature of dependencies is exponential. Keywords: roller grinder, grinding module, cob, corn grain, dependence, linear regression, coefficient of determination