Abstract:Understanding the aerodynamic performance of scaled-down models is vital for providing crucial insights into wind energy optimization. In this study, the aerodynamic performance of a scaled-down model (12%) was investigated. This validates the findings of the unsteady aerodynamic experiment (UAE) test sequence H. UAE tests provide information on the configuration and conditions of wind tunnel testing to measure the pressure coefficient distribution on the blade surface and the aerodynamic performance of the wind turbine. The computational simulations used shear stress transport and kinetic energy (SST K-Omega) and transitional shear stress transport (SST) turbulence models, with wind speeds ranging from 5 m/s to 25 m/s for the National Renewable Energy Laboratory (NREL) Phase VI and 4 m/s to 14 m/s for the 12% scaled-down model. The aerodynamic performance of both cases was assessed at representative wind speeds of 7 m/s for low, 10 m/s for medium, and 20 m/s for high flow speeds for NREL Phase VI and 7 m/s for low, 9 m/s medium, and 12 m/s for the scaled-down model. The results of the SST K-Omega and transitional SST models were aligned with experimental test measurement data at low wind speeds. However, the SST K-Omega torque values exhibited a slight deviation. The transitional SST and SST K-Omega models yielded aerodynamic properties that were comparable to those of the 12% scaled-down model. The torque values obtained from the simulation for the full-scale NREL Phase VI and the scaled-down model were 1686.5 Nm and 0.8349 Nm, respectively. Both turbulence models reliably predicted torque and pressure coefficient values that were consistent with the experimental data, considering specific flow regimes. The pressure coefficient was maximum at the leading edge of the wind turbine blade on the windward side and minimum on the leeward side. For the 12% scaled-down model, the flow simulation results bordering the low-pressure region of the blade varied slightly.

Wind-tunnel experimental study on identification of modal aerodynamic damping matrix for operating wind turbines

Experimental Study on Identification of Aerodynamic Damping Matrix for the Tower of an Operating Wind Turbine by Artificial Excitation

Analysis of Wind Turbine Vibration Characteristics during Startup and Shutdown Process

Analysis of Vibration Monitoring Data of an Onshore Wind Turbine under Different Operational Conditions

Modeling Principle and Parameter Identification of Double Fed Wind Turbine for Electromechanical Transient Simulation of Power System

Aerodynamic Performance and Numerical Validation Study of a Scaled-Down and Full-Scale Wind Turbine Models

Study on the aerodynamic damping for the seismic analysis of wind turbines in operation

Data driven damping separation method for the Mega-offshore wind turbine tower

Scaled Model Test Study of the Dynamic Behavior of an Offshore Wind Turbine Support Structure

Investigation on dynamic performance of wind turbines using different scaling methods in wind tunnel tests

Identification of support structure damping of a full scale offshore wind turbine in normal operation

An experimental study of rotational effects on modal parameters of rotating wind turbine blades

Resonance Monitoring of a Horizontal Wind Turbine by Strain-Based Automated Operational Modal Analysis

Resonance Phenomenon in A Wind Turbine System under Operational Conditions

Modeling and Parameter Analysis of the OC3-Hywind Floating Wind Turbine with a Tuned Mass Damper in Nacelle

Aerodynamic design methodology for wind tunnel tests of wind turbine rotors

Wind tunnel testing of scaled wind turbine models: Beyond aerodynamics

Dynamic Characteristics and Enhanced Performance of a Novel Wind Turbine Rotor Analyzed Via Experiments and Numerical Simulation

An Analytical Frequency‐domain Model of Aerodynamic Mass and Damping of Floating Wind Turbines

Numerical Investigation of Aerodynamic Performances for NREL 5-MW Offshore Wind Turbine

Optimization Study of a Tuned Mass Damper for a Large Monopile Wind Turbine