Abstract:The bond properties at layer interfaces are a required input in mechanistic asphalt pavement models. For design and analysis procedures, involving the calculation of key responses that are commonly linked to performance, perfect bond conditions are regularly assumed between layers. One emerging approach for prolonging the service life of asphalt pavements, either new or rehabilitated, is installing asphalt grid reinforcement (AGR) products between paving lifts. In these cases, the perfect bond assumption may not hold – undermining the reinforcement potential. Accordingly, the objective of this study was to investigate the effects of layer interface properties on key responses in pavements with AGR. The investigation was carried out by combining results from a full-scale construction, laboratory tests on asphalt concrete (AC) cores, and synthetic simulations. The latter were performed with a recently developed semi-analytic mechanistic code that can accept AGR products. This code can handle time- and temperature-dependent layer and interface properties, as well as moving loads. From the laboratory tests, it was found that the bond between AC lifts, with and without an AGR, is time- and temperature-dependent – best characterised by a relaxation interface stiffness function. This relaxation function was measured to be consistently larger without an AGR than with an AGR. Nonetheless, pavement simulations showed that including an AGR has no pronounced effect on strain magnitudes under high-speed/low-temperature conditions, can lessen horizontal strain magnitudes at the reinforced interface and at the AC bottom (mainly under slow-speed/high-temperature conditions, and depending on the installation depth of the AGR), and has no pronounced effect on deflections regardless of the loading speed and temperature level. It is concluded that even if laboratory measurements display a reduced interface stiffness when including an AGR, the reduction may not have any practical implication on key pavement responses, and the reinforcement potential is not necessarily undermined. The modelling and experimental approaches outlined and utilised in this study offer a rational tool for analysing this matter/question on a case-by-case basis.

A Robust Statistical Analysis of Factors Affecting Interface Bonding between Asphalt Pavement Layers

Analysis of the Fatigue Crack Propagation Process of the Stress-Absorption Layer of Composite Pavement Based on Reliability

Fatigue performance of interface bonding between asphalt pavement layers using four-point shear test set-up

STUDY ON STRESS INTENSITY FACTOR AFFECTED BY FRICTION COEFFICIENT BETWEEN SURFACE LAYER AND SUBBASE

Pseudo Energy-Based Crack Initiation Criterion for Asphalt-Filler Composite System under a Fatigue Shear Load

Evaluation of Complex Poisson’s Ratio of Aged Asphalt Field Cores Using Direct Tension Test and Finite Element Simulation

Numerically Supported Experimental Determination of the Behavior of the Interlayer Bond in Asphalt Pavement

Numerical and Experimental Analysis for the Interlayer Behavior of Double-Layered Asphalt Pavement Specimens

Investigation of Fracture Failure and Water Damage Behavior of Asphalt Mixtures and Their Correlation with Asphalt-Aggregate Bonding Performance

Influence of bonding condition of different interfaces on the mechanical responses and failure mode of asphalt pavement

Experimental and numerical modelling of shear bonding between asphalt layers

Role of fiber-reinforced chip seal interlayers in asphalt pavement bonding strength

Characterization of Interface Transition Zone in Asphalt Mixture Using Mechanical and Microscopic Methods

Viscoelastic Analysis of Asphalt Pavement with Reflective Cracks and Subjected to Dynamic Loading

Effects of Asphalt Mixture Type on Asphalt Pavement Interlayer Shear Properties

Test and Evaluation Method of lnterlaminar Shear Performance of Composite Pavement

Mechanistic investigation of grid-reinforced asphalt pavements with measured interface properties

Predictive model for the interface bond strength of geosynthetic-reinforced asphalt layers

Effect of Fractured Aggregate Particles on Linear Stress Ratio of Aggregate and Resilience Properties of Asphalt Mixes—A Way Forward for Sustainable Pavements

Calculation Derivation and Test Verification of Indirect Tensile Strength of Asphalt Pavement Interlayers at Low Temperatures

Study on the influencing factors of mechanical properties of anti-icing modified asphalt mortar