Abstract:This work makes use of experimental and numerical studies to investigate the reduction of braking noise and vibrations of brake disks by introducing various M-shaped grooves on the brake disk frictional surfaces. Experiments with a brake test dynamometer have been carried out to compare the braking vibrations and noise of the grooved disks with that of the un-grooved disk. The experimental results demonstrate that disks with grooves significantly reduced braking vibrations and noise at both low and high frequencies, and as the initial braking temperature and braking pressure increased, the reduction effect is further enhanced. The investigation also shows the wear rates of both the grooved disks and brake pads are also significantly reduced. Thermo-mechanical coupled finite element models of the brake pads and disks with and without grooves are developed to investigate the mechanisms of the reduction of braking noise and vibrations by the introduction of grooves on the disk frictional surfaces. The numerical results show that the number of grooves plays an important role in reducing the interface surface temperatures, enhancing heat flux, reducing thermal deformation, changing the contact pressure distribution, and stabilizing the coefficients of friction of the braking sliding contacts. The thermal effects contribute to the wear reduction of both the braking disks and pads, and the reduction of braking noise and vibrations. In addition, both the finite element modal analysis and the experimental modal testing results show that surface grooves increase the modal damping ratio of the disks, which certainly plays a role on the reduction of braking noise and vibrations. This study has significance to the surface modification of brake disks in order to reduce braking noise and vibrations, as well as the wear resistance of brake disks and pads.

Bicycle disc brake noise analysis and mitigation

The Vibration and Modal Analysis of the Disc Brake

A Study on Chattering Noise of Automobile Disc Brake

Parametric analysis of the relationship between squeal and friction wear in motorcycle disc brakes

Investigation of Multi-Degree of Freedom Damped Dynamic Absorber Applied to Wheel Noise Control

Disc Brake Vibration Model Based on Stribeck Effect and Its Characteristics under Different Braking Conditions

Vibration Energy and Repeated-Root Modes of Disc Rotor for High-Frequency Brake Squeal

Noise and vibration performance of automotive disk brakes with laser-machined M-shaped grooves

Automotive simplex and duplex drum brake squeal analysis using the finite element method

Complex Modal Analysis On A Disc Brake With Thermal Deformation And Rough Surfaces

Modal Based Rotating Disc Model for Disc Brake Squeal

Effect of Pad Shapes on High-Frequency Disc Brake Squeal

Squeal Analysis of a Modal-Parameter-based Rotating Disc Brake Model

Effect of pad shapes on disc brake squeal at high frequency

Prediction and Optimization of the Disc Brake Squeal Performance with Altair HyperWorks and ANSYS

Analysis of disc brake squeal using the complex eigenvalue method

Influence of contact parameters on the radiated noise from an automotive drum brake

Research on cold mechanical vibration of air-cooled disc brake

Validation of Closed-Loop Coupling Disc Brake Model for Squeal Analysis

Nonlinear Behavior Evolution and Squeal Analysis of Disc Brake Based on Different Friction Models

The Prediction of Braking Noise in Regenerative Braking System Using Closed-Loop Coupling Disk Brake Model