Abstract:A wide range of thermoreversible gels are prepared by cooling down to ambient temperature hot aqueous polymer solutions. During the sol-gel transition, such materials may experience a volume contraction which is traditionally overlooked as rheological measurements are usually performed in geometries of constant volume. In this article, we revisit the formation of 1.5% wt. agar gels through a series of benchmark rheological experiments performed with a plate-plate geometry. We demonstrate on that particular gel of polysaccharides that the contraction associated with the sol/gel transition cannot be neglected. Indeed, imposing a constant gap width during the gelation results in the strain hardening of the sample, as evidenced by the large negative normal force that develops. Such hardening leads to the slow drift in time of the gel elastic modulus G′ toward ever larger values, and thus to an erroneous estimate of G′. As an alternative, we show that imposing a constant normal force equals to zero during the gelation, instead of a constant gap width, suppresses the hardening as the decrease of the gap compensates for the sample contraction. As such, imposing a zero normal force is a more reliable way to measure the linear properties of agar gels, which we prove to work equally well with rough and smooth boundary conditions. Using normal force controlled rheology, we then investigate the impact of thermal history on 1.5% wt. agar gels. We show that neither the value of the cooling rate nor the introduction of a constant temperature stage during the cooling process influences the gel elastic properties. Instead, G′ only depends on the terminal temperature reached at the end of the cooling ramp, as confirmed by direct imaging of the gel microstructure by cryoelectron microscopy. Finally, we also discuss two subtle artifacts associated with the use of duralumin plates that may interfere with the rheological measurements of agar gelation. We show that (i) the corrosion of duralumin by the aqueous solution, and (ii) the slow migration of the oil rim added around the sample to prevent evaporation, may both lead separately to a premature and artificial growth of G′ that should not be misinterpreted as the formation of a pregel. The present work offers an extensive review of the technical difficulties associated with the rheology of hydrogels and paves the way for a systematic use of normal force controlled rheology to monitor nonisochoric processes.

Syneresis and delayed detachment in agar plates

Drying of agarose gels monitored by in-situ interferometry

New insight into kinetics behavor of the structural formation process in Agar gelation

Reversibility in the Physical Properties of Agarose Gels following an Exchange in Solvent and Non-Solvent

Spatiotemporal Evolution of Heterogeneous Structures in Agarose Gels Revealed by Particle Tracking

Overcooked agar solutions: impact on the structural and mechanical properties of agar gels

Capillary fracture of ultrasoft gels: heterogeneity and delayed nucleation

Normal force controlled rheology applied to agar gelation

Origins of the Speckles and Slow Dynamics of Polymer Gels

Concentration dependence of the sol-gel phase behavior of agarose-water system observed by the optical bubble pressure tensiometry

Diffusion Wave Spectroscopy Microrheological Characterization of Gelling Agarose Solutions

Syneresis Behavior of Polymer Gels Aged in Different Brines from Gelants

Dynamics of swelling and drying in a spherical gel

Structure and mechanical properties of anisotropic agar gels obtained via unidirectional freezing

Migration of Chemotactic Bacteria in Soft Agar: Role of Gel Concentration

Unconstrained dynamic gel swelling generates transient surface deformations

Direct visualization of pH-dependent evolution of structure and dynamics in microgel suspensions

Gelation impairs small molecule migration in polymer mixtures

Deformation of hydrogel during freezing

Geometrical control of dissipation during the spreading of liquids on soft solids

Interpenetration of fractal clusters drives elasticity in colloidal gels formed upon flow cessation