Abstract:Hypothesis Spreading of liquids on soft solids often occurs intermittently, i.e., the liquid's wetting front switches between sticking and slipping. Studies of this so-called stick-slip wetting on soft solids mostly are confined within quasi-static or forced spreading conditions. In these situations, because the sticking duration is set much larger than the viscoelastic relaxation time of the solid, a ridge is persistently and fully developed at the wetting front as the soft solid yields to the liquid's surface tension. The sticking duration and spreading velocity, therefore, were shown to have little impact to the contact angle change required for stick-to-slip transitions. For unsteady wetting of soft solids, a commonly encountered but largely unexplored situation, we hypothesize that the stick-to-slip transition is controlled not only by a combination of sticking duration and the spreading velocity, but also by an increasing depinning threshold caused by the growing ridge at the wetting front. Experiment We performed unsteady wetting experiment on soft solids by letting water droplets spread freely on soft solid surfaces of various stiffness. We capture both the stick-slip spreading behavior and growing wetting ridges using synchronous high-speed imaging and high-speed interferometry. Recorded data of liquid spreading and solid deforming at the wetting front were analyzed to shed light on the relation between stick-slip characteristics and the growing wetting ridge. Findings We find that intermittent wetting on a soft solid surface results from a competition between three key factors: liquid inertia, capillary force change during sticking, and growing pinning force caused by the solid's viscoelastic response. We theoretically formulate their quantitative contributions to predict how stick-to-slip transitions occur, i.e., how the contact angle change and sticking duration depend on the liquid's spreading velocity and the solid's viscoelastic characteristics. This provides a mechanistic understanding and methods to control unsteady wetting phenomena in diverse applications, from tissue engineering and fabrication of flexible electronics to biomedicine.

Geometrical control of dissipation during the spreading of liquids on soft solids

Wetting Behaviors and Mechanism of Micro Droplets on Hydrophilic Micropillar-Structured Surfaces

Morphology and stability of droplets sliding on soft viscoelastic substrates

Spreading on viscoelastic solids: Are contact angles selected by Neumann's law?

Spontaneous Motion of Liquid Droplets on Soft Gradient Surfaces

Universality of Droplet Impingement: Low-to-High Viscosities and Surface Tensions

Emergence and Growth Dynamics of Wetting-induced Phase Separation on Soft Solids

Liquid Nanodroplets Spreading on Chemically Patterned Surfaces

Surface structure determines dynamic wetting

Unsteady wetting of soft solids

Slip-Mediated Dewetting of Polymer Microdroplets

Spreading of a viscoelastic drop on a solid substrate

Energetic Analysis of Drop’s Maximum Spreading on Solid Surface with Low Impact Speed

Rapid wetting of shear-thinning fluids

Spreading dynamics of microdroplets on nanostructured surfaces

Discontinuous dewetting dynamics of highly viscous droplets on chemically heterogeneous substrates

Near-wall depletion and layering affect contact line friction of multicomponent liquids

Droplet impact on rotating surfaces: The effect of centrifugal force and wettability on spreading dynamics

Spreading of graphene oxide suspensions droplets on smooth surfaces

Droplet leaping governs microstructured surface wetting