Abstract:The total energy distributions (TEDs) of the emission currents in field emission and surface photofield emission and the overlayer-induced modifications in the surface electronic structures from the technologically important W surfaces with the commensurate W(100)/Na c(2x2), W(110)/Na (2x2) and W(111)/Na (1x1) overlayers are calculated. The TEDs obtained by our recent numerical method that extends the full-potential linear augmented plane wave method for the electronic structures to the study of field and photofield emission are used to interpret the shifts of the peaks in the experimental TEDs in field emission and photofield emission from the W(100) and W(110) surfaces at sub-monolayer and monolayer Na coverage. Hybridization of the 3s Na states with the pairs of dz2-like surface states of the strong Swanson hump in clean W(100) and surface resonances in clean W(111) below the Fermi energy shifts these W states by about -1.2 eV and -1.0 eV, thus stabilizing these states, to yield new strong peaks in the TEDs in field emission and photofield emission from W(100)/Na c(2x2) and W(111)/Na (1x1) respectively. The effect of Na intralayer interactions are discussed and are shown to shift the strong s- and p-like peaks in the surface density of states of W(110) below and above the Fermi energy respectively to lower energy with increased Na coverage, in agreement with experiments.

What problem does this paper attempt to address?

The problem that this paper attempts to solve is to study the influence of sodium (Na) overlayers on the electronic structure, field emission, and photo - field emission current of low - index tungsten (W) surfaces. Specifically, the author focuses on the changes in the total energy distributions (TEDs) of these surfaces under different sodium overlayer conditions (such as W(100)/Na c(2×2), W(110)/Na (2×2), W(111)/Na (1×1)) and their interpretations of experimental results. ### Main problems of the paper 1. **Understanding the influence of sodium overlayers on the electronic structure of tungsten surfaces** - How do sodium overlayers change the electronic structure of tungsten surfaces? Especially for W(100), W(110) and W(111) surfaces. - How do these changes affect the characteristics of field emission (FE) and photo - field emission (PFE)? 2. **Interpreting experimentally observed emission peaks** - How are the emission peaks (such as Swanson hump) observed in the experiment formed? - What causes the changes of these peaks under different sodium overlayers? 3. **Comparison between theoretical calculations and experimental results** - Can the theoretical calculations carried out by the full - potential linear - augmented plane - wave method (FP - LAPW) accurately predict the phenomena observed in the experiment? - How to explain certain specific phenomena in the experiment, such as the new strong peak F1 appearing on the W(100)/Na c(2×2) surface? 4. **Investigating the influence of sodium overlayers on the work function** - How do sodium overlayers reduce the work function of tungsten surfaces? - What is the significance of this reduction for practical applications (such as thermionic cathodes and photo - emitting devices)? ### Formula representation - Total Energy Distributions (TEDs): \[ \text{TED}(E)=\sum_{\mathbf{k}} f(\mathbf{k}, E) \] where \( f(\mathbf{k}, E) \) is the Fermi - Dirac distribution function. - Energy shift of surface states: \[ E_{\text{shifted}} = E_{\text{initial}}+\Delta E \] where \( \Delta E \) is the energy shift caused by the sodium overlayer. - Calculation of work function: \[ \phi = V_{\text{vacuum}}-E_F \] where \( V_{\text{vacuum}} \) is the vacuum potential and \( E_F \) is the Fermi level. Through the research of these problems, the author hopes to provide a microscopic - mechanism - based explanation for understanding and improving the performance of devices based on the tungsten - sodium interface, and to reveal the roles of surface states and surface resonances in substrate - overlayer bonding.

Surface Electronic Structures and Field Emission Currents at Sodium Overlayers on Low-Index Tungsten Surfaces

Surface Effects on the Dual-Mode Vibration of < 1 1 0 > Silver Nanowires with Different Cross-Sections

Field-induced Hot-Electron Emission Model for Wide-Band-gap Semiconductor Nanostructures

Study Of The Na-Si(111) 3x1 Interface Using Core-Level Photoemission Spectroscopy

STUDIES OF Na ADSORBED ORDERLY AND DISORDERLY ON Si(111) SURFACE USING PES

Surface Properties of Rare-Earth Metals and the Effects of Their Substitutional Doping on Work Function of the W(110) Surface

Surface Vs. Bulk Electronic Structure of Silver Determined by Photoemission

Effect of the Surface States of Different Transition-Metal Substrates on a Cs Overlayer.

The electronic structure of the Na$_x$CoO$_2$ surface

Probing the Surface Effect on Deep-Level Emissions of an Individual ZnO Nanowire Via Spatially Resolved Cathodoluminescence

Sodium Adsorption on the Surface of Thermally Oxidized Tungsten

Structural, electronic, vibrational, optical and thermoelectric properties of 1T-Na 2 O monolayer via MD and DFT study

Work function and surface stability of tungsten-based thermionic electron emission cathodes

Computational study on the electronic states of tungsten nitride molecule

Theoretical Study on the Surface Core-Level Eigen-Energy Shifts of Ca(100)

Interaction and surface photovoltage effect of MoS2 with Na deposition

Surface Polaron Self-Energy And Effective Mass In A Wurtzite Gan Nanowire

He nanobubble driven W surface growth during low-energy He ion irradiations

A calcium pump in plasma membrane vesicles from Leishmania braziliensis.

Eels Analysis Of Surface-Channeled Electrons

Surface Chemical Control Of The Electronic Structure Of Silicon Nanowires: Density Functional Calculations