Effect of thermal exposure on microstructure and mechanical properties of Ti65 high-temperature titanium alloy deposited by laser direct energy deposition

Junfeng Sun,Haifei Lu,Hongmei Zhang,Kaiyu Luo,Jinzhong Lu

DOI: https://doi.org/10.1016/j.msea.2024.146757

2024-06-08

Materials Science & Engineering A: Structural Materials: Properties, Microstructure and Processing

Abstract:Industrial design and new product development benefit from the adaptable processing approach offered by laser direct energy deposition (LDED). In this paper, a novel Ti65 alloy was successfully prepared by LDED and subjected to thermal exposure at 650 °C and 750 °C, respectively. The results showed that the as-deposited microstructure varies in different regions due to the cooling rate. Silicide precipitation was observed at the α/β interface, and a coherent α 2 phase was generated in the matrix after thermal exposure at 650 °C. Two-scale silicides were observed at the α/β interface and inside the α laths after thermal exposure at 750 °C. The as-deposited ultimate tensile strength (UTS) was 1058 MPa and 690 MPa at room temperature and 650 °C, respectively. After thermal exposure at 650 °C, the room temperature UTS was 1135 MPa, and the elongation (EL) at 650 °C was 27.5%. After thermal exposure at 750 °C, the room temperature EL was 11.05%, and both UTS and EL at 650 °C showed a decrease. The quantitative analysis showed that silicide precipitation was primarily responsible for the strengthening mechanism of the specimens thermally exposed at 650 °C at room temperature. The results provide scientific data for the manufacture of Ti65 alloy with excellent mechanical properties, laying the foundation for its application in aerospace.