Abstract:High quality stoichiometric magnetite (Fe3O4) films grown by infrared pulsed laser deposition (IR-PLD) on different surfaces were investigated in order to study the influence of the substrate, orientation, and thickness on their magnetic behavior. Different single crystal (001)-oriented substrates, i.e., SrTiO3(001), MgAl2O4(001) and MgO(001), have been used for the preparation of epitaxial Fe3O4(001) films. By comparison, polycrystalline magnetite films were obtained on both single crystal Al2O3(0001) and amorphous Si/SiO2 substrates. The thickness has been varied between 50 - 400 nm. All films consist of nanocrystalline stoichiometric magnetite with very small strain (<1\%) and present the Verwey transition (Tv) between 110-120 K, i.e., close to bulk magnetite (122 K). In general, Tv depends on both microstructure and thickness, increasing mainly as the thickness increases. Room temperature angular-dependent measurements reveal an in-plane fourfold symmetry magnetic behavior for all films grown on (001)-oriented surfaces, and with the easy axes lying along the Fe3O4 [010] and [100] directions. Remarkably, the fourfold magnetic symmetry shows up to 400 nm thick films. In turn, the films grown on single crystal Al2O3 (0001) and on amorphous Si/SiO2 surfaces display an isotropic magnetic behavior. Coercive field (Hc) depends on microstructure and film thickness. The largest (lowest) Hc value corresponds to the thinner film grown on a single crystal SrTiO3(001) (amorphous Si/SiO2) surface, which present the largest (lowest) strain (crystallinity). Moreover, the coercivity follows an inverse law with film thickness. Our results demonstrate that we can artificially control the magnetic behavior of stoichiometric IR-PLD grown Fe3O4 films by exploiting substrate-induced anisotropy and thickness-controlled coercivity, that might be relevant to incorporate magnetite in future spintronic devices.

A Robust Approach for the Growth of Epitaxial Spinel Ferrite Films

Epitaxial Growth of Spinel Cobalt Ferrite Films on MgAl$_2$O$_4$ Substrates by Direct Liquid Injection Chemical Vapor Deposition

Epitaxial Zn(x)Fe(3-x)O(4) Thin Films: A Spintronic Material with Tunable Electrical and Magnetic Properties

Epitaxy of Fe3O4 on Si(001) by pulsed laser deposition using a TiN/MgO buffer layer

Growth of Mixed Phased Films of Γ-Fe2o3and Half Metallic Fe3O4using (100) MgO/Fe under Layer for Spin Electronic Devices

Growth and process conditions of aligned and patternable films of iron(III) oxide nanowires by thermal oxidation of iron.

Growth Temperature Dependent Evolutions of Microstructural, Optical and Magnetic Properties of Zn0.75Co0.25O Films

Realization of high-quality Sr4Fe6O13 epitaxial film and its phase competition with SrFeO2.5

Epitaxial Growth and Observation of the Magnetodielectric Effect in Ferrimagnetic Lu3Fe5O12 Films

Epitaxial growth of Fe3O4 thin films on ZnO and MgO substrates

Enhanced magnetic moment and conductive behavior in NiFe2O4 spinel ultrathin films

Growth of Flexible NiFe2O4 Thin Films Via Van Der Waal Heteroepitaxy

High temperature diffusion enabled epitaxy of the Ti-O system

Growth and characterization of Fe3O4 films

Epitaxial growth of complex oxides on silicon by enhanced surface diffusion in large area pulsed laser deposition

Epitaxial Lift-Off of Centimeter-Scaled Spinel Ferrite Oxide Thin Films for Flexible Electronics.

Growth Dependencies of Epitaxial Oxide Thin Films Prepared by Pulsed Laser Deposition

Exploiting Kinetics And Thermodynamics To Grow Phase-Pure Complex Oxides By Molecular-Beam Epitaxy Under Continuous Codeposition

Towards magnetic control of magnetite

Ultra-low temperature epitaxial growth of lithium ferrite thin films by high-pressure sputtering

Quantitative Strain Analysis and Growth Mode of Pulsed Laser Deposited Epitaxial CoFe2O4 Thin Films