Abstract:In order to ease the manufacture process of very large permanent magnet (PM) machines, such as direct drive wind power generators, modularity technique is usually adopted. Although conventional fractional slot PM machines with all teeth wound windings show good performance, the coils located at the end part of each segment could be easily damaged because of being exposed to the air. In addition, the local winding faults could easily proliferate to the whole machine due to the physical touch of adjacent coils. Thus, a novel modular fractional slot PM machine with redundant teeth is proposed in this paper, while three phases within each set of winding are still balanced. The construction of the proposed modular PM machine having 42-slots/32-poles (42S/32P) combination is described in detail as an example, which can be treated as the integration of six 6S/5P segments and a redundant 6S/2P machine. The reason for using 6S/2P machine is to get rid of the undesirable unbalanced magnetic force (UMF), which usually exists in rotating asymmetric machines, such as 3S/2P PM machine. Since the end part of each segment in the proposed modular PM machine can be covered by half redundant tooth during the production, more protection can be provided for coils located in these regions. Furthermore, the separation of six segments can improve the fault-tolerant capability of the machine. The electromagnetic performance predicted by finite-element analysis (FEA) also demonstrates that the proposed modular machine will perform better if dual three-phase winding is adopted. Finally, the experiments on the prototyped machine validate the analysis in the paper.

Study of Characteristics According to Pole–Slot Combination of Fractional Slot Concentrated Winding Permanent Magnet Synchronous Motor

Solution of Permanent Magnet Synchronous Motors with Partition between Poles Halbach Magnet

Influence of Stator Topologies on Average Torque and Torque Ripple of Fractional-Slot SPM Machines with Fully Closed Slots

Novel Modular Fractional Slot Permanent Magnet Machines with Redundant Teeth

Optimal Split Ratio in Fractional-Slot Interior Permanent-Magnet Machines With Non-Overlapping Windings

Design Optimization and Performance Investigation of Linear Doubly Salient Slot Permanent Magnet Machines

Influence of Design Parameters on Output Torque of Novel Doubly-Fed Flux-Switching Permanent Magnet Machines

Winding Configurations and Pole/Tooth Combinations of Doubly-Fed Flux-Switching Permanent Magnet Machines

Design Consideration of Fractional Slot Concentrated Winding Interior Permanent Magnet Synchronous Motor for EV and HEV Applications

A study on motor characteristics based on pole-slot combinations

Slot/Pole Number Combination Research of-PM Linear Motors With Fractional Slots per Pole

Fractional Slot Concentrated Winding PMSM With Consequent Pole Rotor for a Low-Speed Direct Drive: Reduction of Rare Earth Permanent Magnet

Comparative Investigation Of Single-Sided And Double-Sided Permanent Magnet Linear Motor

Analysis of a Novel Linear Doubly Salient Slot Permanent Magnet Motor

Design and Analysis of a 500W 120000rpm High-Speed Permanent Magnet Motor

Electromagnetic and Thermal Coupling Analysis of a Water-Cooled Double-Sided Permanent Magnet Linear Synchronous Motor

Study on Stator Groove and Rotor Pole Combination of Permanent Magnet Brushless DC Motor

Comparative Study of 6-Slot/2-pole High-Speed Permanent Magnet Motors with Different Winding Configurations

Evaluation of Fractional Slot Concentrated Winding Permanent Magnet Synchronous Machine for Electric Vehicle Application

Design and Optimization of a Slotless High-speed Permanent-Magnet Synchronous Motor with Non-magnetic Fillers in Stator

Design and Analysis of Interior Permanent Magnet Motor With Magnetic Isolation and Heat Dissipation Integrated Auxiliary Slot