Abstract:This paper presents a flame retardant 4 (FR4)-based electromagnetic scanning micromirror, which aims to overcome the limitations of conventional microelectromechanical systems (MEMS) micromirrors for the large-aperture and low-frequency scanning applications. This micromirror is fabricated through a commercial printed circuit board (PCB) technology at a low cost and with a short process cycle, before an aluminum-coated silicon mirror plate with a large aperture is bonded on the FR4 platform to provide a high surface quality. In particular, an electromagnetic angle sensor is integrated to monitor the motion of the micromirror in real time. A prototype has been assembled and tested. The results show that the micromirror can reach the optical scan angle of 11.2 ∘ with a low driving voltage of only 425 mV at resonance (361.8 Hz). At the same time, the signal of the integrated angle sensor also shows good signal-to-noise ratio, linearity and sensitivity. Finally, the reliability of the FR4 based micro-mirror has been tested. The prototype successfully passes both shock and vibration tests. Furthermore, the results of the long-term mechanical cycling test (50 million cycles) suggest that the maximum variations of resonant frequency and scan angle are less than 0.3% and 6%, respectively. Therefore, this simple and robust micromirror has great potential in being useful in a number of optical microsystems, especially when large-aperture or low-frequency is required.

Deeply-Etched MEMS Slotted Micromirrors With Controlled Transmittance

The Effects of Reflection Phase Shift on the Optical Properties of a Micro-Opto-electro-mechanical System Fabry–Perot Tunable Filter

Analysis and Optimization of a Novel Laterally Deformable Optical NEMS Grating Transducer

Optical-Electromechanical Performance of Mems Tilting Micro-Mirrors for Aon Communication System

Analysis of Optical Diffraction Profiles Created by Phase-Modulating MEMS Micromirror Arrays

Novel MEMS Torsional Mirror Optical Switch

Physical Parameter Extraction and Modeling of Metallized Deeply-Etched Vertical Mirrors

Single-mode and Wavelength Tunable Lasers Based on Deep-Submicron Slots Fabricated by Standard UV-lithography

Design and Performance of MEMS Multifunction Optical Device Using a Combined In-Plane and Out-of-Plane Motion of Dual-Slope Mirror

Simulation, Optimization and Measurement of MEMS Torsion Micro Mirrors for Optical MEMS Application

Experimental Study on Roughness and Flatness of Micromirror Fabricated by Different Anisotropic Silicon Etching Processes

A Novel Variable Optical Attenuator Based on Micro-Electromechanical System (MEMS)

The Fabrication of 16*16 MEMS-Based Optical Switch with Accurate Optical Fiber Grooves Integration

Micromechanical Variable Optical Attenuator Based on EDM Micromachining

Research On The Dynamic Performance Of Mems Micromirrors

State-of-the-Art Materials Used in MEMS Micromirror Arrays for Photonic Applications

Electromagnetically Driven MEMS Micromirror with Torsion Beam Structure

Development of an Optoelectronic Integrated Sensor for a MEMS Mirror-Based Active Structured Light System

FR4-Based Electromagnetic Scanning Micromirror Integrated with Angle Sensor

Design, Fabrication and Characterization of Novel Micromirror with Vertical Torsion Comb Driver

3D Surface Topography and Reflectivity of Anisotropic Etched Silicon Micromirrors for BioMEMS