Abstract:In the field of civil aviation, the nose landing gear is a critical component that is prone to damage during taxiing. With the advent of new technologies such as towing taxi-out and hub motors, the nose landing gear faces increasingly complex operational environments, thereby imposing higher performance demands. Ensuring the structural safety of the nose landing gear is fundamental for the successful application of these technologies. However, current research on aircraft nose landing gear under these new conditions is somewhat lacking, particularly in terms of reliable analysis models for real-world scenarios. This study focuses on a typical Class C aircraft, specifically the B-727 model, for which a finite element model of the nose landing gear is developed. Modal testing of the aircraft's nose landing gear is conducted using the impact hammer method, and the results are compared with those from the simulations. The experimental data indicate that the error range for the first seven natural frequencies is between 0.23% and 9.27%, confirming the high accuracy of the developed landing gear model. Furthermore, with towing taxi-out as the primary scenario, a dynamic model of the aircraft towing system is established, and an analysis on the structural strength and topological optimization of the nose landing gear under various conditions, including high speeds and heavy loads, is performed. The results show that the developed model can effectively support the analysis and prediction of the mechanical behavior of the nose landing gear. Under high-speed, heavy-load conditions, the nose landing gear experiences significantly increased loads, with the maximum deformation primarily occurring at the lower section of the shock strut's outer cylinder. However, no damage occurred. Additionally, under these conditions, an optimized structural design for the landing gear was identified, which, while ensuring structural strength, achieves a 22.32% reduction in the mass of the outer cylinder, also ensuring safety in towing taxi-out conditions.

Experimental and numerical research of aircraft tire debris impact on landing gear brake pipe

A Numerical Study on the High-Velocity Impact Behavior of Pressure Pipes

Experimental and numerical analysis of composite fuselage panel impacted by tire burst debris under airworthiness clause

Numerical Study of CFRP-Bonded Pressure Pipes Subject to Impact Load

Experimental and numerical study of tire debris impact on fuel tank cover based on coupled Eulerian-Lagrangian method

Modeling of Fatigue Mechanism and Reliability Analysis of Nose Landing Gear under Impact Loading

Dynamic response of aircraft tire bursting debris under internal pressure

Landing Impact Load Analysis and Validation of a Civil Aircraft Nose Landing Gear

Hydrodynamic Effects in Wing Fuel Tank Caused by Debris Impact

Dynamic simulation on down landing gear undercarriage system of aircraft

Structural Strength Analysis and Optimization of Commercial Aircraft Nose Landing Gear under Towing Taxi-Out Conditions Using Finite Element Simulation and Modal Testing

The Influence of Landing Gear Structural Parameters on Aircraft Wheel Shimmy

Thermo-mechanical-abrasive Coupling Analysis of Solid Rubber Tire under High-Speed Rolling

Dynamic Response of Pressurized Gas Pipes Subjected to Transverse Impact Loads

Improved Multi-Body Dynamic Simulation of Landing Gear Drop Test Incorporating Structural Flexibility and Bearing Contact

An Experimental Investigation on the Impact Perforation Failure of Water-Filled-Pressurized Pipelines

Numerical Simulations of Complex Water Spray Flows Around Aircraft Landing Tire

The Effects of Load Conditions and Structural Parameters on Fretting Wear of Annular Flat in Heavy-Duty Gas Turbine

Experimental and Numerical Investigation on Radial Impact of Pneumatic Tyre

Dynamic Ductile Fracture Toughness Test and Numerical Simulation for Ultra-High Pressure Gas Pipelines

Comparative Research on Landing and Rollout Characteristics of Skid-Equipped and Wheeled Aircraft