Abstract:The current 5G and future 6G high-speed mobile-Internet era puts forward stricter requirements on the power consumption, silicon area, and phase noise specifications for local oscillators (LOs) in mobile and portable devices, especially in battery-powered mobile phones, notebook computers, and unmanned aerial vehicles (UAVs) used for mobile base stations. Over the past few decades, intensive research to improve the power efficiency of RF and millimeter-wave oscillators while maintaining required phase-noise characteristic has been carried out. As represented in Fig. 8.1.1, the authors in [1] reported a BiCMOS series-resonance VCO with the lowest phase noise among silicon-based oscillators identified in [1] at the cost of high power consumption (600mW), which is not feasible for energy-efficient applications. In addition to the series resonance technique, the commonly used method to reduce the phase noise is to introduce a high resistance at the second harmonic frequency. However, the head filter in [2] that generates the high resistance occupies additional area and cannot prevent noise current injection at the GND. Although separate filters are added at the VDD and GND, as reported in [3], the noise current passing through the head common-mode inductance is coupled in the same phase to the noise current of the bottom inductance, which increases the total injected noise to some extent. To solve the problem of the additional area for the common-mode resonator, the authors in [4] merged the common-mode filter with the differential-mode resonator at the cost of the reduced switching speed of the gate and worsened phase noise and the ability to cut off the noise-injection path from the VDD coupled to the gate. In order to overcome the above-mentioned issues, a 11.5-to-14.3GHz dual-core Class-F VCO with common-mode-noise self-cancellation and isolation technique is proposed in this paper. Without occupying additional area, the injection noise of the VDD and the GND is cancelled inherently at the same time, and the noise path from the drain to gate is isolated. The measurement results indicate that the proposed common-mode-noise self-cancellation and isolation VCO achieves -119.2dBc/Hz phase noise at 1MHz offset from a carrier of 11.8GHz, which translates to an FoM of 192.8dBc/Hz. The reported FoM is competitive among VCOs operating in a nearby frequency range.

Tail‐free fast start‐up 1 mW 5 G voltage controlled oscillator for new radio application

A 60GHz voltage-controlled oscillator with a 3.6GHz tuning range in 180nm CMOS technology

A Low Power Sub-GHz PLL with Optimized Class-C Voltage-controlled Oscillator

A Compact Square-Geometry Quad-Core 19 GHz Class-F VCO with Parallel Inductor-sharing Technique achieving -137.2 dBc/Hz Phase Noise at 10MHz Offset

A 3 GHz Low Power LC VCO with Voltage Boosted Circuit from 0.5 V Supply

A 4.4-Ghz 193.2-Db FoM 8-Shaped-inductor Based LC-VCO Using Orthogonal-Coupled Triple-Coil Transformer

An Ultra-Low-Voltage High-Performance VCO in 0.13 μm CMOS

An Ultra-Wideband VCO Using Digitally Controlled Varactor Arrays in 40-Nm CMOS Technology

Design of low power and low phase noise LC-VCO for Bluetooth/WLAN applications

CMOS Voltage-Controlled Oscillator with Complementary and Adaptive Overdrive Voltage Control Structures

A 0.73 Mw Low Power 9.6 GHz LC Voltage-Controlled Oscillator Achieves Constant KVCO and −189.2 FOM

A 57&#x223c;66ghz CMOS Voltage-Controlled Oscillator Using Tunable Differential Inductor

A 2.7-Mw 1.36–1.86-Ghz LC-VCO with a FOM of 202 Dbc/hz Enabled by a 26%-Size-reduced Nano-Particle-Magnetic-Enhanced Inductor

A 194.9dbc/hz FoM and 6.8-to-11.6ghz Quad-Core Dual-Mode Class-F VCO Featuring Wideband Flicker Noise Suppression

Design of a 60 GHz, 11.7% Tuning-Range Voltage-Controlled Oscillator in 65 Nm CMOS Technology

8.1 an 11.5-to-14.3ghz 192.8dbc/hz FoM at 1mhz Offset Dual-Core Enhanced Class-F VCO with Common-Mode-Noise Self-Cancellation and Isolation Technique

Analysis and design of a new low‐phase noise and Gm‐enhanced class‐C quadrature VCO

Class-C VCO with Amplitude Feedback Loop for Robust Start-Up and Enhanced Oscillation Swing

A Wideband Fast Start-Up Multi-Core VCO With Auto-Frequency Control in 0.18 μm CMOS

A 5.8 GHz Implicit Class-F VCO in 180-nm CMOS Technology

A 28-GHz–195-dB FoMA 3.72-GHz/V Class-B/C Nested-gm VCO With Coupled Tail Filtering in a 65-nm CMOS