Abstract:Empirical wear transition maps have been constructed to delineate the load velocity conditions under which wear transitions occurred in an A356 AI alloy and an A356 Al20%SiC composite. Experiments were performed in dry sliding conditions, using a block-on-ring (SAE 52100) configuration, within a load range of 0.2–400 N and a sliding velocity range of 0.2–5.0 m s−1. Both materials displayed transitions from mild to severe wear at specific load and sliding velocity combinations. The mild wear regime for the composite was expanded to a higher range of sliding speeds and loads by comparison with unreinforced A356 Al. Within the mild regime, two sub-regimes existed for both materials, namely where mixing/oxidation occurred at low sliding speeds to produce a thermally insulating surface layer, and another at higher speeds where this layer was removed. In the composite an additional wear transition, i.e. from mild to ultra-mild regime, occurred at low loads and velocities where the wear rates of the composite were at least two orders of magnitude lower than unreinforced A356 Al, due to the load supporting effect of the particles at the contact surfaces. In both materials, the transition from mild to severe wear occurred at conditions where the surface (bulk) temperature exceeded a critical value of approximately 125 °C in the A356 Al and 338 °C for the composite. The temperature data were summarised in the form of surface temperature maps on log load versus log velocity axes.Wear mechanisms in each regime were determined using scanning electron microscopy, and energy dispersive spectroscopy techniques that were used to analyse morphologies, microstructures and chemical compositions of worm surfaces and wear debris. The dominant mechanisms in each regime were identified and correlated with wear rate and temperature map data to summarise the effects of reinforcement on wear rates and transitions.

Prediction of Steady-State Wear Coefficients in Adhesive Wear

Experimental Investigation of Friction and Wear Behavior of AL7075-TiO2-B4C using RSM, ANN and Desirability Function

Surface Wear Rate Prediction in Reinforced AA2618 MMC by Employing Soft Computing Techniques

Mathematical Modeling of Wear Characteristics of 6061 Al-Alloy-SiCp Composite Using Response Surface Methodology

Micromechanics of material detachment during adhesive wear: A numerical assessment of Archard's wear model

Experimental Analysis and Wear Prediction Model Based on Friction Heat for Dry Sliding Contact

Wear prediction for metals

Adhesive wear behavior of AlxCoCrCuFeNi high-entropy alloys as a function of aluminum content

Dry sliding wear behavior of additively manufactured CoCrWNixAly alloys

The Wear Resistance Mechanisms and Decision of Critical Normal Load for In-situ Granular γ+(Fe, Mn)3C/γ Steel Matrix Composites

Tribological behavior of high-entropy alloy particle reinforced aluminum matrix composites and their key impacting factors

Frictional Study on 30CrNi2MoVA Steel Based on Experiments and Finite Element Simulation: Wear Prediction

Experimental Investigation of the Influence of Various Wear Parameters on the Tribological Characteristics of AZ91 Hybrid Composites and Their Machine Learning Modeling

Correlating numerical modelling with experimental studies to quantify the wear resistance of high-carbon chromium bearing steel in mixed lubrication

Wear mechanism maps for metal matrix composites

Prediction of tribological performance of AA8011/wt.%ZrO2 based composites fabricated by stir casting route

Prediction of Archard's wear coefficient for metallic sliding friction assuming a low cycle fatigue wear mechanism

Wear Behavior of Iron Based Alloys with Different Entropy Extent Estimated by Miedema's Model

Mechanical and dry sliding tribological characteristics of aluminium matrix composite reinforced with high entropy alloy particles

Analysis of the friction and wear of graphene reinforced aluminum metal matrix composites using machine learning models

Influence Factors on Wear Resistance of Two Alumina Matrix Composites