Abstract:Electrophoretic deposition (EPD) silicon–zirconium organic–inorganic hybrid coatings were applied on LC4 aluminum alloy for corrosion protection. 3-Glycidoxypropyl-trimethoxysilane (GTMS) and Zirconium (IV) n-propoxide (TPOZ) were used as precursors. 3-Aminopropyl-trimethoxysilane (APS) was added to enhance the corrosion protective performance of the coatings. Scanning electron microscopy (SEM), energy dispersive X-ray spectroscopy (EDS) and Fourier transform infrared spectroscopy (FTIR) were employed to characterize morphology, microstructure and component. The results show that the addition of APS leads to the enhanced migration and deposition of positively charged colloidal particles on the surface of metal substrate, which results in the thickness increasing of coatings. However, loading an excessive amount of APS gives a heterogeneous coating surface. The corrosion protective performance of coatings were measured by electrochemical impedance spectroscopy (EIS) and potentiodynamic polarization. The results indicate that the addition of APS improves corrosion protective performance of coatings. The optimal addition content of APS is about 15%. The 15% APS coating is uniform and dense, as well as has good corrosion protective performance. The impedance value (1.58×105Ω·cm2, at the lowest frequency) of 15% APS coating is half order of magnitude higher than that of coating without APS, and 15% APS coating always keeps the best corrosion protective performance with prolonged immersion time. This kind of coating is identified with “double-structure” properties based on the analysis of EIS and potentiodynamic polarization. Furthermore, the equivalent circuit results indicate that the intermediate oxide layer plays a main role in corrosion protection.

Excellent performance of dodecyl dimethyl betaine and calcium gluconate as hybrid corrosion inhibitors for Al alloy in alkaline solution

Anti-corrosion Performance of LY12 Al Alloy Reinforced by Anodic Oxidization and Silanization

A Sol–bath–gel Approach to Prepare Hybrid Coating for Corrosion Protection of Aluminum Alloy

Corrosion resistance of anodically oxidized LY12 aluminum alloy after modification with cerium nitrate and silane

Hyperbranched molecules having multiple functional groups as effective corrosion inhibitors for Al alloys in aqueous NaCl

Sodium dodecyl sulfate (SDS) as an effective corrosion inhibitor for Mg-8Li-3Al alloy in aqueous NaCl: A combined experimental and theoretical investigation

Effect of Nano-SiO2 Hybrid Coatings on Corrosion Resistance of Aluminum Alloys

Enhanced Corrosion Protection by Al Surface Immobilization of In-Situ Grown Layered Double Hydroxide Films Co-Intercalated with Inhibitors and Low Surface Energy Species

Enhanced corrosion protection of AZ31B magnesium alloy by MgAl-LDHs composite coatings double-doped with imidazolium ionic liquid and sodium dodecylbenzenesulphonate

Inhibitive effect of anionic/ zwitterionic hybrid surfactants on the self-corrosion of anode for alkaline Al-air battery

Enhanced corrosion resistance of ammonium heptamolybdate (AHM) sealed Li Al LDHs conversion coating on aluminum alloy

Active Release of Diatomite-Mgal-layered Double Hydroxide Nanostructures on Corrosive Inhibitors to Effectively Suppresses Corrosion of LA51 Alloy

Electrophoretic deposition of hybrid coatings on aluminum alloy by combining 3-aminopropyltrimethoxysilan to silicon–zirconium sol solutions for corrosion protection

Catechol/m-Phenylenediamine Modified Sol–Gel Coating with Enhanced Long-Lasting Anticorrosion Performance on 3003 Al Alloy

Enhanced active corrosion protection coatings for aluminum alloys with two corrosion inhibitors co-incorporated in nanocontainers

Insight into synergistic corrosion inhibition of sodium benzoate and sodium silicate on LZ91 magnesium alloy: Experimental and theoretical calculations

Enhanced Corrosion Resistance of Layered Double Hydroxide Films on Mg Alloy: The Key Role of Cationic Surfactant

Synergistic corrosion inhibition of sodium phosphate and sodium dodecyl sulphate on magnesium alloy AZ91 in 3.5 wt% NaCl solution

Biomimetic superhydrophobic matrix constructed on a buffer aluminum layer: A compositing coating for Mg-Li alloy corrosion inhibition

Corrosion Resistance of Dicalcium Phosphate Dihydrate/poly(lactic-Co-glycolic Acid) Hybrid Coating on AZ31 Magnesium Alloy

Improving Environmental Adaptability and Long-Term Corrosion Resistance of Mg Alloys by Pyrazole Ionic Liquids: Experimental and Theoretical Studies