Abstract:A numerical emissive hollow cathode model which couples plasma and thermal aspects of the NASA NSTAR cathode has been presented in a companion paper and simulation results obtained using the plasma model were compared to experimental data. We now compare simulation results with measurements using the full coupled model. Inside the cathode, the simulated plasma density profile agrees with the experimental data up to the ±50% experimental uncertainty while the simulated emitter temperature differs from measurements by at most 5 K. We then proceed to an analysis of the cathode discharge both inside the cathode where electron emission is dominant and outside in the near plume where electron transport instabilities are important. As observed previously in the literature, the total emitted electron current is much larger than the set discharge current collected at the anode while ionization plays a negligible role. Extracted electrons are emitted from a region much shorter than the full emitter ( versus ). The influence of an applied axial magnetic field in the plume is also assessed and we observe that it leads to a 10-fold increase of the plasma density 1 cm downstream of the orifice entrance while the simulated discharge potential at the anode is increased from up to Lastly, we perform a parametric study on both the operating point (discharge current, mass flow rate) and design (inner radius) of the cathode. The simulated useful operating envelope is shown to be limited at low discharge current mostly because of the probable ion sputtering of the emitter and at high discharge current because of emitter evaporation, plasma oscillations and sputtering of the keeper electrode. The behavior of the cathode is also analyzed w.r.t. its internal radius and simulation results show that the useful emitter length scales linearly with the cathode radius.

Non-local model of hollow cathode and glow discharge - theory calculations and experiment comparison

Integral equation for source of ionization in hollow cathode

Uniqueness theorem for the non-local ionization source in glow discharge and hollow cathode

Longitudinal structure and plasma parameters of an entire DC glow discharge as obtained using a 1D fluid-based model with non-local ionization

Hollow cathode modeling: I. A coupled plasma thermal two-dimensional model

Hollow cathode modeling: II. Physical analysis and parametric study

The Nonlocal Electron Kinetics for a Low-Pressure Glow Discharge Dusty Plasma

Investigation Of Low-Pressure Glow Discharge In A Coaxial Gridded Hollow Cathode

On Fundamental Inconsistencies in a Commonly Used Modification of a Fluid Model for Glow Discharge

Numerical Simulation for Low Pressure DC Argon Glow Discharge

Glow discharge in low pressure plasma PVD: mathematical model and numerical simulations

Transition characteristics of low-pressure discharges in a hollow cathode

Cathode Fall Characteristics in a Dc Atmospheric Pressure Glow Discharge

Establishing Criteria for the Transition from Kinetic to Fluid Modeling in Hollow Cathode Analysis

Simulation of Ionization-Wave Discharges: a Direct Comparison Between the Fluid Model and E-FISH Measurements

Anomalous Glow Discharge between Two Electrodes on the Same Surface in a Transverse Magnetic Field

Simulation on the hollow cathode discharge in hydrogen

Modeling on plasma energy balance and transfer in a hollow cathode

Transition From Glow Microdischarge To Arc Discharge With Thermionic Cathode In Argon At Atmospheric Pressure

A Kinetic Model for Non-Local Thermodynamic Equilibrium Plasmas

Numerical Simulation of the Voltage–Current Characteristic of an Atmospheric Pressure Discharge: The Glow-to-Arc Transition