Abstract:CaO–MgO–Al2O3–SiO2 glass ceramic was successfully prepared from blast furnace slag (BFS), which was the raw material, by the one-step thermal treatment. The comprehensive crystallization characteristic, phase transition, kinetic parameters of crystallization, microstructural evolution, and orientation relations between diopside and spinel were investigated using differential scanning calorimetry, X-ray diffraction, scanning electron microscopy, and electron backscatter diffraction. Experimental results revealed that the beginning of crystallization and the end of nucleation overlapped. A thermal nucleation treatment applied in the special temperature region (791–840 °C) confirmed the coexistence of spinel and diopside by modern analytical methods, providing direct evidence of achieving bulk crystallization via the one-step method. Traditional spinel, which typically includes Fe, induces the formation of diopside. However, the spinel phase in this study did not contain sufficient Fe because the Fe content in the BFS was small. This suggests that the Mn-containing spinel phase served as the nucleation agent. The epitaxial growth mechanism was confirmed to be diopside {200}//spinel {111}, diopside [001]//spinel [112]. Moreover, glass ceramic crystallized at 980 °C has better corrosion resistance and has an acid and alkaline resistance of 96.64% and 99.41%, respectively. The one-step preparation of glass ceramic has profound significance in terms of energy saving and waste utilization. Furthermore, the results of this study have a guiding significance for the industrialization of the glass ceramic prepared by the one-step method.

Direct preparation of magnesium borate (Mg2B2O5) ceramic from boron-bearing slag: Super-gravity separation and microwave dielectric properties

Fabrication of Y2O3-doped MgO Refractory Raw Materials Based on Magnesium Hydroxide from Salt-Lake Brine

Unleashing the Potential of Mg2SiO4-based Ceramics for Millimeter-Wave Applications: Achieving Ultra-Low Loss with Enhanced Temperature Stability Through Heterovalent Ion Substitution

Competitive crystallization of B, Si, and Mg and two-stage separation of olivine and suanite from boron-bearing slag in supergravity field

Preparation of B2O3-P2O5-SiO2 glass-ceramics by the sol-gel method

One‐step preparation of glass‐ceramics from a ferrochrome slag and an electrolytic manganese slag

Effect of Mg/B ratio and Sr2+ substitution for Mg2+ on the sintering, phase composition and microwave dielectric properties of Mg3B2O6 ceramics

Preparation and properties of porous MgO based ceramics from magnesite tailings and fused magnesia

Activated treatment of magnesite for preparing size-controlled Mg2B2O5 whiskers and their microwave dielectric properties

Three‐phase borate solid solution with low sintering temperature, high‐quality factor, and low dielectric constant

High sintering and dielectric performance: The improved (Mg, Zn)3B2O6 ceramics with the help of the DFT calculation

Preparation and characterization of foamed glass-ceramics based on waste glass and slow-cooled high-titanium blast furnace slag using borax as a flux agent

Crystallization of CaO–MgO–Al2O3–SiO2 glass ceramic derived from blast furnace slag via one-step method

Low Dielectric Constant Borophosphosilicate Glass–ceramics Derived from Sol–gel Process

Influence of B2O3 on Dielectric, Mechanical, and Thermal Properties of MgO-Al2O3-SiO2 Glass-Ceramics

Flux-Assisted Thermal Conversion Route To Pore-Free High Crystallinity Magnesium Borate Nanowhiskers At A Relatively Low Temperature

Microwave dielectric properties of low-temperature-fired MgNb2O6 ceramics for LTCC applications

Preparation of BaO–MgO–Al2O3–SiO2/Al2O3 glass-ceramic/ceramic LTCC substrate material for microwave application

Sintering behaviour and microwave dielectric properties of MgO-2B2O3-xwt%BaCu(B2O5)-ywt%H3BO3 ceramics

A novel method for efficient recovery of boron from boron-bearing iron concentrate: Mineral phase transformation and low-temperature separation via super-gravity

Preparation of glass–ceramics from blast furnace slag and its heavy metal curing properties