Abstract:The fabrication process, sintering cycles through two sintering methods, microstructural and texture characterization, mechanical properties, and electrical conductivity of metal paste-deposited copper parts were investigated in this study. In the first condition, samples were air-debinded for carbon content removal followed by a sintering cycle. A sintering profile with the maximum sintering temperature and time of 1080 °C and 1 hr. was implemented after performing the air-debinding cycle at 250 °C for 2 hrs. In the second condition, samples were sintered in the environment of copper oxide for carbon removal in the early stages of the sintering cycle, i.e., 1070 °C for 1 hr and 1080 °C for 1, 2, and 3 hrs. The microstructural observations revealed coarser grains in the air-debinded samples, perhaps due to additional generated heat during carbon oxide formation, which may produce destructive effects on the boundary (HAGBs, twins, and CSL) volume and densification behavior of copper parts. However, through the second method, much finer grains and higher densities of boundaries were detected in the microstructure. Despite the significant effect of sintering conditions on the microstructure, texture interpretations revealed minor changes in the pole figures for different situations. Using the second sintering method and owing to the less carbon content and based on the density of the boundaries and their configurations, higher electrical conductivity (98.4±1.3 % IACS) was recorded by sintering the green parts. The comparison between the data from this study with other parts printed through other additive manufacturing techniques demonstrated a superior electrical conductivity level and acceptable balance between strain and strain notably with the sample sintered for 3 hrs.

Rapid and full densification of carbonized polymer dot/copper composites by low‐temperature sintering

Sintering Densification of Cu/Al2O3p Nano-Composite Powders by Electroless Copper Plating

Influence of carbonized polymer dot (CPD) structure on mechanical and electrical properties of copper matrix composite

High strength-tough and super-dispersed carbonized polymer dots reinforced copper composites fabricated by ultrasonic spray pyrolysis

Achieving a better mechanical enhancing effect of carbonized polymer dots than carbon nanotubes and graphene in copper matrix

Synthesis process and microstructure of carbon fibres/graphite/copper composites by spark plasma sintering

Microstructure and Properties of W Cu Composites with Low Copper Content at Different Sintering Temperatures

Densification and Properties Investigation of W-Mo-Cu Composites Prepared by Large Current Electric Field Sintering with Different Technologic Parameter

Simultaneously enhanced strength and ductility of copper composites by tailoring the intragranular carbonized polymer dots distribution

Facile Synthesis of High-Performance Carbon Nanosheet/cu Composites from Copper Formate

Synthesis and Characterization of Highly-Dispersed Copper Submicron Particles for Low Temperature Sintering Joints

Enhancing the mechanical and electrical conductivity of copper matrix composites through grafting carbonized polymer dots (CPD) onto carbon nanotube surfaces

Rapid Low Temperature Sintering in Air of Copper Submicron Particles with Synergistic Surface-Activation and Anti-Oxidative Protection

Thermodynamic Behavior of Copper-Coated Silicon Carbide Particles during Conventional Heating and Spark Plasma Sintering

Enhancing densification rate and the unusual 4H-SiC polytype stabilization in ultrafast high-temperature sintering of α-SiC

Cold Sintering Process of Composites: Bridging the Processing Temperature Gap of Ceramic and Polymer Materials

Sintering process optimization of the additively manufactured pure copper parts through the metal paste deposited process

Densification of Cu-15wt%Cr composite powders prepared by mechanical milling

Effect of silver plating and sintering temperature on the microstructure and mechanical properties of carbon fiber reinforced Cu matrix composites

Cold Sintering Process for a BaTiO3/Poly(vinylidene difluoride) Ceramic-Polymer Composite: Evaluation of the Structural and Microwave Dielectric Properties

Densification of Mechanically Milled 3%C-Cu Composite Powders by Hot Extrusion