Abstract:Large-mode-area photonic crystal fiber is used to generate high power, high beam quality supercontinuum. Propagation and supercontinuum generation process of laser pulse in large-mode-area (LMA) photonic crystal fiber (PCF) is simulated by solving the general nonlinear Schrödinger equation (GNLSE) using the split-step Fourier method. Effects of the pump pulse parameters (peak power and chirp) and the length of photonic crystal fiber used on supercontinuum generation are particularly estimated. Nonlinear spectral broadening mechanism of laser pulse in large-mode-area photonic crystal fiber is discussed. The results show that the process of supercontinuum generation can be divided into three stages: initial broadening, dramatic broadening and saturation broadening. The spectrum width and efficiency can be achieved by the optimized length of LMA PCF to insure output of the generated supercontinuum at the dramatic broadening stage. The pump peak power and chirp have important impact on supercontinuum generation. When a small peak power pump is input, the spectrum broadens symmetrically. When the pump peak power increases, it brings little changes with the shorter wavelength component but broader of the longer wavelength component. The time-domain shape of the pulse exhibits concussion modulation as the effect of pulse breakup. When the pump chirp is positive, little influence is shown, except a shift of longer wavelength power by increasing the chirp. But the full width of the supercontinuum has little changes. While the pump chirp is negative and satisfy certain condition, the nonlinear is enhanced to facilitate the supercontinuum generation.

Continuous-wave supercontinuum laser based on an erbium-doped fiber ring cavity incorporating a highly nonlinear optical fiber

Supercontinuum Generation in Submicrometer Diameter Silica Fibers

Low-threshold supercontinuum generation in semiconductor nanoribbons by continuous-wave pumping.

Supercontinuum generation based on nanofiber

High Power, Continuous-wave Supercontinuum Generation in Highly Nonlinear Fibers Pumped with High Order, Cascaded Raman Fiber Amplifiers

Generation Of Broadband Continuous-Wave Supercontinuum Raman Lasing In A Fiber Ring Cavity

Supercontinuum Generation in Photonic Crystal Fiber and Tapered Single-Mode Fiber

High power, high efficiency, continuous-wave supercontinuum generation using standard telecom fibers

Supercontinuum generation triggered by a weak 100-kHz linewidth continuous-wave

All-Fiber Wideband Supercontinuum Generation in Short Hybrid Highly Nonlinear Fibers With a Femtosecond Erbium-Doped Fiber Laser

Fiber-Integrated Reversibly Wavelength-Tunable Nanowire Laser Based on Nanocavity Mode Coupling.

More than 100 channels CW optical frequency chain generation from single supercontinuum source for DWDM systems

All Fiberized Supercontinuum Laser Source Based on “figure of Eight” Cavity Modelocked Yb Fiber Laser

Two octave supercontinuum generation in a non-silica graded-index multimode fiber

74 Nm, 2.5 GHz Supercontinuum Generation in a Dispersion-Shifted Fiber

Femtosecond 5-W Yb:KGW Slab Laser Oscillator Pumped by a Single Broad-Area Diode and Its Application As Supercontinuum Source

Novel Bidirectional Output Ytterbium-Doped High Power Fiber Lasers: From Continuous to Quasi-Continuous

Supercontinuum generation with high power efficiency in a highly nonlinear fiber pumped by two-color pulses

High Power, Tunable, Continuous-Wave Fiber Lasers in the L-Band Using Cascaded Raman Amplifiers

Combination of highly nonlinear fiber, an optical bandpass filter, and a Fabry-Perot filter to improve the signal-to-noise ratio of a supercontinuum continuous-wave optical source.

Supercontinuum generation and control from large-mode-area photonic crystal fiber