Abstract:The nano/microstructuring of silicon (Si) via chemical methods has garnered significant attention due to its excellent light-trapping capabilities across a wide spectral range. Current research has predominantly focused on the synthesis of pyramidal-shaped microtextures, which enable two reflections on the surface, while largely overlooking the superior light-trapping potential of inverted pyramid silicon (SiIP) microtextures, which theoretically allow for three reflections. Moreover, there has been limited investigation into the application of inverted pyramid black silicon for solar-driven hydrogen evolution. This study reports the synthesis of uniformly arranged inverted pyramid-textured black silicon using the copper-assisted chemical etching (Cu-ACE) method to enhance the efficiency of solar-driven water splitting for hydrogen production. The formation mechanism and the influence of copper-localized surface plasmon resonance (Cu-LSPR) from Cu nanoparticle (NP) byproducts on photoelectrochemical (PEC) activity were systematically analyzed. To reduce sidewall defects and minimize photogenerated carrier recombination, the surface of the SiIP was treated with tetramethylammonium hydroxide (TMAH). A vertical PN junction was developed through ion implantation to reduce the external bias of the SiIP. Additionally, a uniform TiO2 antireflective layer was deposited via atomic layer deposition (ALD), reducing the average reflectance of the SiIP-T-4 to 5.78 % over the 300-1100 nm wavelength range. MoSx and Pt NPs were electrodeposited to improve the fill factor and enhance HER kinetics. With optimized catalyst loading, the n(+)p-SiIP-T-4/TiO2/Pt 80 mC electrode achieved a photocurrent density of 8.0 mA cm(-2) at 0 V vs. RHE, an applied bias photon-to-current efficiency (ABPE) of 0.93 % at 0.24 V vs. RHE, and a double-layer capacitance (Cdl) of 91 mu F cm(-2). The onset potential (Von) was positively shifted by similar to 1.13 V to 0.49 V vs. RHE compared to a SiIP photocathode, and the photocathode operated continuously at 0 V vs. RHE for 27 h in an acidic electrolyte. These results demonstrate that SiIP has significant potential for PEC hydrogen evolution, with further performance optimization achievable through structural and surface engineering.

Improving Silicon Photocathode Performance for Water Reduction through Dual Interface Engineering and Integrating ReS 2 Photocatalyst

Improving Silicon Photocathode Performance for Water Reduction Through Dual Interface Engineering and Integrating ReS2 Photocatalyst

High Performance P-Si/ni3s2 Photocathode for Photoelectrochemical Hydrogen Evolution in Neutral Solution

Silicon Based Photoelectrodes for Photoelectrochemical Water Splitting

Strategies for Improving Photoelectrochemical Water Splitting Performance of Si‐based Electrodes

Dissolution-Induced Surface Reconstruction of Ni0.95Pt0.05Si/p-Si Photocathode for Efficient Photoelectrochemical H2 Production

In Situ Integration of ReS2/Ni3S2 P-N Heterostructure for Enhanced Photoelectrocatalytic Performance.

Surface Engineering of Nanoporous Silicon Photocathodes for Enhanced Photoelectrochemical Hydrogen Production

Surface/Interface Engineering of Si-Based Photocathodes for Efficient Hydrogen Evolution

Enhanced Capability of Hydrogen Evolution Photocathode by Laminated Interface Engineering of Co/MoS2 QDs/pyramid-black Si

Engineering the Siox Interfacial Layer of Si-Based Metal-Insulator-Semiconductor Junction for Photoelectrochemical Hydrogen Production

NiSi 2 /p-Si Schottky Junction Photocathode with a High-Quality Epitaxial Interface for Efficient Hydrogen Evolution

Ti/Co-S catalyst covered amorphous Si-based photocathodes with high photovoltage for the HER in non-acid environments

Efficient Photoelectrochemical Hydrogen Evolution on Silicon Photocathodes Interfaced with Nanostructured NiP2 Cocatalyst Films.

More than 10% efficiency and one-week stability of Si photocathodes for water splitting by manipulating the loading of the Pt catalyst and TiO2 protective layer

Development of A Corrosion-Resistant Amorphous Silicon Carbide Photoelectrode for Solar-To-Hydrogen Photovoltaic/Photoelectrochemical Devices

Enhanced Solar Hydrogen Evolution by Laminated Integration of N+P-Siip/Tio2/Pt Inverted Pyramid Black Si Photocathode

Design of a Silicon Photocatalyst for High-Efficiency Photocatalytic Water Splitting.

Enhanced Capability of Hydrogen Evolution Photocathode by Laminated Interface Engineering of Co/MoS 2 QDs/pyramid-black Si

Efficient N+p-Si Photocathodes for Solar H2 Production Catalyzed by Co-W-S and Stabilized by Ti Buffer Layer

High‐Performance Si Photocathode Enabled by Spatial Decoupling Multifunctional Layers for Water Splitting